SC16C754BIBM-S NXP Semiconductors, SC16C754BIBM-S Datasheet - Page 27

• Manufacturer Part Number: SC16C754BIBM-S
• Manufacturer: NXP Semiconductors

Specifications of SC16C754BIBM-S

• Transmit Fifo: 64Byte
• Receive Fifo: 64Byte
• Transmitter And Receiver Fifo Counter: Yes
• Data Rate: 5Mbps
• Package Type: LQFP
• Operating Supply Voltage (max): 5.5V
• Mounting: Surface Mount
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Lead Free Status / RoHS Status: Compliant

NXP Semiconductors
SC16C754B_4
Product data sheet
7.6 Modem Control Register (MCR)
The MCR controls the interface with the modem, data set, or peripheral device that is
emulating the modem.
Table 14.
[1]
Bit
7
6
5
4
3
2
1
0
MCR[7:5] can only be modified when EFR[4] is set, that is, EFR[4] is a write enable.
Symbol
MCR[7]
MCR[6]
MCR[5]
MCR[4]
MCR[3]
MCR[2]
MCR[1]
MCR[0]
Modem control register bits description
[1]
[1]
[1]
5 V, 3.3 V and 2.5 V quad UART, 5 Mbit/s (max.) with 64-byte FIFOs
Rev. 04 — 6 October 2008
Description
Clock select.
TCR and TLR enable.
Xon Any.
Enable loopback.
IRQ enable OP.
FIFO Ready enable.
RTS
DTR
Table 14
logic 0 = divide-by-1 clock input
logic 1 = divide-by-4 clock input
logic 0 = no action
logic 1 = enable access to the TCR and TLR registers
logic 0 = disable Xon Any function
logic 1 = enable Xon Any function
logic 0 = normal operating mode
logic 1 = enable local loopback mode (internal). In this mode the
MCR[3:0] signals are looped back into MSR[7:4] and the TX output is
looped back to the RX input internally.
logic 0 = forces INTA to INTD outputs to the 3-state mode and OP
output to HIGH state
logic 1 = forces the INTA to INTD outputs to the active state and OP
output to LOW state. In loopback mode, controls MSR[7].
logic 0 = disable the FIFO Rdy register
logic 1 = enable the FIFO Rdy register. In loopback mode, controls
MSR[6].
logic 0 = force RTS output to inactive (HIGH)
logic 1 = force RTS output to active (LOW). In loopback mode, controls
MSR[4]. If auto-RTS is enabled, the RTS output is controlled by
hardware flow control.
logic 0 = force DTR output to inactive (HIGH)
logic 1 = force DTR output to active (LOW). In loopback mode, controls
MSR[5].
shows modem control register bit settings.
SC16C754B
© NXP B.V. 2008. All rights reserved.
27 of 51