KSZ8041TL A3 TR Micrel Inc, KSZ8041TL A3 TR Datasheet - Page 21

• Manufacturer Part Number: KSZ8041TL A3 TR
• Manufacturer: Micrel Inc

Specifications of KSZ8041TL A3 TR

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Micrel, Inc.
Strapping Options – KSZ8041MLL
Note:
Pin strap-ins are latched during power-up or reset. In some systems, the MAC receive input pins may drive high during
power-up or reset, and consequently cause the PHY strap-in pins on the MII signals to be latched high. In this case, it is
recommended to add 1K pull-downs on these PHY strap-in pins to ensure the PHY does not strap-in to ISOLATE mode,
or is not configured with an incorrect PHY Address.
December 2009
Pin Number
1. Ipu/O = Input with internal pull-up (40K +/-30%) during power-up/reset; output pin otherwise.
Ipd/O = Input with internal pull-down (40K +/-30%) during power-up/reset; output pin otherwise.
22
21
20
27
41
40
29
43
23
42
Pin Name
CONFIG2
CONFIG1
CONFIG0
NWAYEN
PHYAD2
PHYAD1
PHYAD0
DUPLEX
SPEED
ISO
Type
Ipd/O
Ipd/O
Ipu/O
Ipd/O
Ipd/O
Ipd/O
Ipd/O
Ipu/O
Ipu/O
Ipu/O
(1)
Pin Function
The PHY Address is latched at power-up / reset and is configurable to any value from
1 to 7.
The default PHY Address is 00001.
PHY Address bits [4:3] are always set to ‘00’.
The CONFIG[2:0] strap-in pins are latched at power-up / reset and are defined as
follows:
ISOLATE mode
During power-up / reset, this pin value is latched into register 0h bit 10.
SPEED mode
During power-up / reset, this pin value is latched into register 0h bit 13 as the Speed
Select, and also is latched into register 4h (Auto-Negotiation Advertisement) as the
Speed capability support.
DUPLEX mode
During power-up / reset, this pin value is latched into register 0h bit 8 as the Duplex
Mode.
Nway Auto-Negotiation Enable
During power-up / reset, this pin value is latched into register 0h bit 12.
CONFIG[2:0]
000
001
010
011
100
101
110
111
Pull-up = Enable
Pull-down (default) = Disable
Pull-up (default) = 100Mbps
Pull-down = 10Mbps
Pull-up (default) = Half Duplex
Pull-down = Full Duplex
Pull-up (default) = Enable Auto-Negotiation
Pull-down = Disable Auto-Negotiation
Mode
MII (default)
Reserved – not used
Reserved – not used
Reserved – not used
MII 100Mbps Preamble Restore
Reserved – not used
MII back-to-back
Reserved – not used
21
KSZ8041TL/FTL/MLL
M9999-120909-1.2