CPC5602C Clare, CPC5602C Datasheet - Page 15

• Manufacturer Part Number: CPC5602C
• Description: MOSFET N-CH 350V 5MA SOT-223
• Manufacturer: Clare

Specifications of CPC5602C

• Fet Type: MOSFET N-Channel, Metal Oxide
• Fet Feature: Depletion Mode
• Rds On (max) @ Id, Vgs: 14 Ohm @ 50mA, 350mV
• Drain To Source Voltage (vdss): 350V
• Current - Continuous Drain (id) @ 25° C: 5mA
• Input Capacitance (ciss) @ Vds: 300pF @ 0V
• Power - Max: 2.5W
• Mounting Type: Surface Mount
• Package / Case: SOT-223 (3 leads + Tab), SC-73, TO-261
• Transistor Polarity: N-Channel
• Resistance Drain-source Rds (on): 14 Ohms
• Continuous Drain Current: 5 mA
• Power Dissipation: 2.5 W
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Gate Charge (qg) @ Vgs: -
• Vgs(th) (max) @ Id: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Modem S-Registers
Setting the Highest Line Rate
The connect rate can be selected by S-register S37. The following connect rates are supported.
Rev. 2
S37
Value
0
4
5
6
S21
S22
S23
S24
S25
S26
S27
S28
S29
S37
Register
Range
Reserved
Reserved
Reserved
Reserved
0 - 255
Reserved
Reserved
0 - 255
0 - 255
0 - 6
Carrier
V.22, Bell 212A
V.22bis
Units
Reserved
Reserved
Reserved
Reserved
seconds or
1/100 sec.
Reserved
Reserved
minutes
1/50th sec
code
Data Rate
The data rate of the last AT command
Reserved
1200 bps. See the B command
2400 bps
Description
Reserved
Reserved
Reserved
Reserved
During synchronous operation with the &Q1 command in effect, S-register S25 is
the number of seconds after a telephone line connection is made before the modem
examines DTR. This allows sufficient time to disconnect the modem from an asyn-
chronous terminal and attach it to a synchronous terminal. In the On-Line or
Command state during any mode of operation, changes in DTR for less than S25
hundredths of a second are ignored.
Reserved
Reserved
Terminal inactivity timeout. Hangs up the modem after S28 minutes if no characters
are received from the modem’s terminal. Default = 0
Hook Flash On-Hook time. The amount of time in 20 millisecond units the modem
will leave the telephone on-hook while performing a hook-flash according to the “!”
dial string modifier. Default = 25 fiftieths of a second.
Set Highest Line Rate - determines the highest telephone line data rate the modem
will use when connecting with a remote modem. See “Setting the Highest Line
Rate” section below. Default = 0.
www.clare.com
CPC2400E
15