STEVAL-MKI107V1 STMicroelectronics, STEVAL-MKI107V1 Datasheet - Page 8

• Manufacturer Part Number: STEVAL-MKI107V1
• Description: Power Management Modules & Development Tools L3G4200D Adapter BRD MEMS Evaluation
• Manufacturer: STMicroelectronics
• Type: Other Power Managementr

Specifications of STEVAL-MKI107V1

• Product: Power Management Development Tools
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Demonstration kit description
8/32
Table 1.
●
●
eMotion also integrates six LEDs and three buttons:
●
●
●
●
●
J1 connector
the code through the JTAG or SWD protocols.
Jumper JP7
fitted) mode.
LED D1
LEDs D2 and D3
MEMS digital adapters (if available on the sensor mounted on the adapter board).
LEDs D4, D5, and D6
indicate some firmware state. For example, LED D6 is switched on when a specific
firmware is selected from those available. LED D5 on indicates that the microcontroller
is well configured for communication with the sensor. Finally the LED D4, blinks
according to the sensor data rate selected.
Button SW3
Button SW1 and SW2
are available to the user.
JP4
JP5
JP6
PD
HP
ST
Jumper configuration for power-down (PD), self test (ST) and high-pass
filter reset (HP)
(Figure
(Figure
(Figure
(Figure
3, ref 6) is switched on when the board is power supplied.
(Figure
logic level 1: external
logic level 1: self test
high-pass filter reset
3, ref 4) is used to select either JTAG (JP7 unfitted) or SWD (JP7
logic level 1: power-
3, ref 1) is used to reset the STM32.
3, ref 3) can be used to both reprogram the STM32 and to debug
(Figure
Jumper on 1-2
(Figure
down mode
3, ref 13) are directly connected to the interrupt pins of the
Doc ID 17768 Rev 1
position
ON
3, ref 12) are general purpose LEDs and are used to
3, ref 2 and ref 5) are connected to STM32 GPIOs and
Power-down is handled
High-pass filter reset is
Self test is handled by
Jumper on 2-3
by the firmware
handled by the
the firmware
position
firmware
logic level 0: self test
logic level 0: normal
logic level 0: normal
Jumper unfitted
mode, default
mode, default
OFF, default
UM0979