STA328 STMicroelectronics, STA328 Datasheet - Page 16

• Manufacturer Part Number: STA328
• Description: DIG AUDIO SYSTEM, 2-CH, 36POWERSSOP
• Manufacturer: STMicroelectronics

Specifications of STA328

• Svhc: No SVHC (15-Dec-2010)
• Package / Case: PowerSO
• Interface: I2C
• No. Of Pins: 36
• Operating Temperature Range: -20°C To +125°C
• Supply Voltage Max: 36V
• Supply Voltage Min: 10V
• Termination: RoHS Compliant
• Interface Type: I2C
• Rohs Compliant: Yes

I
5
5.1
5.2
16/57
2
C bus specification
I
The STA328 supports the I
to the I
that controls the data transfer is known as the master and the other as the slave. The master
always starts the transfer and provides the serial clock for synchronization. The STA328 is
always a slave device in all of its communications.
Communication protocol
Data transition or change
Data changes on the SDA line must only occur when the SCL clock is low. SDA transition
while the clock is high is used to identify a START or STOP condition.
Start condition
START is identified by a high to low transition of the data bus SDA signal while the clock
signal SCL is stable in the high state. A START condition must precede any command for
data transfer.
Stop condition
STOP is identified by a low to high transition of the data bus SDA signal while the clock
signal SCL is stable in the high state. A STOP condition terminates communication between
STA328 and the bus master.
Data input
During the data input the STA328 samples the SDA signal on the rising edge of clock SCL.
For correct device operation the SDA signal must be stable during the rising edge of the
clock and the data can change only when the SCL line is low.
Device addressing
To start communication between the master and the STA328, the master must initiate with a
start condition. Following this, the master sends 8 bits (MSB first) onto the SDA line
corresponding to the device select address and read or write mode.
The 7 MSBs are the device address identifiers, corresponding to the I
STA328 device address is decimal 34 (binary 00100010).
The 8th bit (LSB) identifies read or write operation, RW. This bit is set to 1 in read mode and
0 for write mode. After a START condition the STA328 identifies the device address on the
bus. If a match is found, it acknowledges the identification on the SDA bus during the 9th bit
time. The byte following the device identification byte is the internal space address.
2
C bus specification
2
C bus as a transmitter and any device that reads the data as a receiver. The device
2
C protocol. This protocol defines any device that sends data on
2
C bus definition. The
STA328