ATZB-24-A2 Atmel, ATZB-24-A2 Datasheet - Page 18

• Manufacturer Part Number: ATZB-24-A2
• Description: KIT MOD 802.15.4/ZIGB 2.4GHZ ANT
• Manufacturer: Atmel

Specifications of ATZB-24-A2

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: Home/Building Automation, Industrial Control and Monitoring
• Power - Output: 3dBm
• Sensitivity: -101dBm
• Voltage - Supply: 1.8 V ~ 3.6 V
• Current - Receiving: 19mA
• Current - Transmitting: 18mA
• Data Interface: PCB, Surface Mount
• Memory Size: 128kBytes Flash, 8kBytes RAM, 4kBytes EEPROM
• Antenna Connector: On-Board, Chip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Tool Type: Wireless Development Kit
• Core Architecture: AVR
• Cpu Core: AVR 8
• Data Bus Width: 8 bit
• Description/function: ZigBit 2.4 GHz Dual Chip Antenna
• Wireless Frequency: 2.4 GHz
• Interface Type: UART, I2C, SPI
• Operating Voltage: 1.8 V to 3.6 V
• Output Power: 3 dBm
• Antenna: Chip Antenna
• Operating Temperature Range: - 40 C to + 85 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

10. System Clock and Clock options
10.1
10.2
8069Q–AVR–12/10
Features
Overview
•
•
•
•
•
•
•
•
•
XMEGA A4 has an advanced clock system, supporting a large number of clock sources. It incor-
porates both integrated oscillators, external crystal oscillators and resonators. A high frequency
Phase Locked Loop (PLL) and clock prescalers can be controlled from software to generate a
wide range of clock frequencies from the clock source input.
It is possible to switch between clock sources from software during run-time. After reset the
device will always start up running from the 2 Mhz internal oscillator.
A calibration feature is available, and can be used for automatic run-time calibration of the inter-
nal 2 MHz and 32 MHz oscillators. This reduce frequency drift over voltage and temperature.
A Crystal Oscillator Failure Monitor can be enabled to issue a Non-Maskable Interrupt and
switch to internal oscillator if the external oscillator fails.
cipal clock system in XMEGA A4.
Fast start-up time
Safe run-time clock switching
Internal Oscillators:
External clock options
PLL with internal and external clock options with 1 to 31x multiplication
Clock Prescalers with 1 to 2048x division
Fast peripheral clock running at 2 and 4 times the CPU clock speed
Automatic Run-Time Calibration of internal oscillators
Crystal Oscillator failure detection
– 32 MHz run-time calibrated RC oscillator
– 2 MHz run-time calibrated RC oscillator
– 32.768 kHz calibrated RC oscillator
– 32 kHz Ultra Low Power (ULP) oscillator with 1 kHz ouput
– 0.4 - 16 MHz Crystal Oscillator
– 32 kHz Crystal Oscillator
– External clock
Figure 10-1 on page 19
XMEGA A4
shows the prin-
18