69912 Tyco Electronics, 69912 Datasheet - Page 3

• Manufacturer Part Number: 69912
• Description: DIE SOLIS 69082 300-350MCM
• Manufacturer: Tyco Electronics

Specifications of 69912

• Lead Free Status / RoHS Status: Not applicable / Not applicable

5. CRIMP INSPECTION
Inspect crimped terminals and splices by checking the
features described in Figure 4. Use only the terminals
and splices that meet the conditions shown in the
“ACCEPT” column. “REJECT” terminals and splices
can be avoided through careful use of instructions in
Section 4, CRIMPING PROCEDURE, and by
performing regular die maintenance as described in
Section 6, MAINTENANCE AND INSPECTION.
6. MAINTENANCE AND INSPECTION
6.1. Maintenance
Crimping Die Assemblies 69911, 69912, 69913, and 69914
ACCEPT
1. Remove dust, moisture and other contaminants
B
Parallel
Splice
Terminal
Butt
Splice
Figure 4
6.2. Inspection
Regular inspections should be performed with a
record of inspections remaining with the dies and/or
supervisory personnel responsible for them. Tyco
Electronics recommends one inspection per month;
Parallel
Splice
with a clean brush, or a soft, lint–free cloth. Do not
use objects that could damage the dies.
2. Make sure that dies are properly aligned and
that die holding screws are in place and secured.
3. Make certain that all surfaces are protected with
a thin coat of any good SAE 20 motor oil. Do not
oil excessively.
4. When dies are not in use, store in a clean, dry
area.
Terminal
408-2671
REJECT
Butt
Splice
3