679305-1 Tyco Electronics, 679305-1 Datasheet - Page 5

• Manufacturer Part Number: 679305-1
• Description: TOOL HEAD TETRA CRIMP ADPT ASSY
• Manufacturer: Tyco Electronics

Specifications of 679305-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

Pneumatic TETRA-CRIMP Adapter 679305-1
3. Remove the two retaining rings from the link on
the wire stop side. Remove the link. Take the wire
stop spring off of the wire stop. Remove the wire
stop. Replace the link. Squeeze the front half of
both crimping jaws together until the jaws are
bottomed. Measure the jaw closure area using the
proper plug gage element as follows:
4. If the jaw closure meets the plug gage
conditions, the crimping chambers may be
considered dimensionally correct and should be
reassembled and lubricated with a THIN coat of
any high quality SAE 20 motor oil. If the crimping
chambers do not conform to the plug gage
conditions provided in Figure 6, contact your local
Tyco Electronics Representative, or refer to
Section 6, REPLACEMENT AND REPAIR.
D
CRIMPING CHAMBER
a. Align the GO element with the crimping
chamber. Push the GO element straight into the
crimping chamber from the wire stop side of the
crimping assembly without using force. The GO
element must pass completely through the
crimping chamber as shown in Figure 6,
Detail A.
b. Align the NO–GO element with the crimping
chamber; then try to insert it straight into the
crimping chamber. The NO–GO element may
start entry but must not pass completely
through, as shown in Figure 6, Detail B.
COLOR CODE
Suggested Plug Gage Design
GO
NO
GO
GO
Figure 6
For additional information about the use of a plug
gage, see Instruction Sheet 408–7424.
6. REPLACEMENT AND REPAIR
Replaceable parts are listed in Figure 5. Parts other
than those listed in Figure 5 should be replaced by
Tyco Electronics to ensure quality and reliability of the
tool. Order replacement parts through your Tyco
Electronics Representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
For tool repair service, please contact a Tyco
Electronics Representative at 1–800–526–5136.
7. REVISION SUMMARY
Since the previous release of this sheet, the following
changes were made:
GAGE ELEMENT DIMENSIONS
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
S Updated document to corporate requirements
S New format
Detail A
NO-GO
WIDTH (Max)
Detail B
408-4099
5