1-45216-0 Tyco Electronics, 1-45216-0 Datasheet - Page 4

• Manufacturer Part Number: 1-45216-0
• Description: TOOL HEAD CRIMP SPLICE 22-14AWG
• Manufacturer: Tyco Electronics

Specifications of 1-45216-0

• Connector Type: Terminals and Splices
• Crimp Handle: 1213563-1, 1213804
• Crimp Or Cable Size: 14-22 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable

If the crimping chamber passes the gage inspection,
the crimping head is considered dimensionally correct
and should be lubricated with a THIN coat of any
good SAE 20 motor oil. If the crimping chamber does
not conform to the plug gage conditions, contact your
local Tyco Electronics Field Representative or refer to
Section 6, REPLACEMENT AND REPAIR.
For additional information about the use of a plug
gage, see Instruction Sheet 408–7424.
4
Configuration
Jaw Closure
TOOL NUMBER
TOOL NUMBER
2. Close wire barrel crimping jaws until they are
bottomed, but not under pressure.
3. Align GO element with wire barrel crimping
section. Push element straight into crimping
chamber without using force. The GO element
must pass completely through the chamber as
shown in Figure 5.
4. Align the NO–GO element and try to insert it
into the chamber. The element may start entry, but
it must not pass completely through the crimping
chamber.
Suggested Plug Gage Design
Figure 4
GAGE ELEMENT DIAMETER
GO
Closed End Splice Crimping Heads
NO-GO
6. REPLACEMENT AND REPAIR
Order replacement heads through your Tyco
Electronics Representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
For further repair and replacement information,
call the Tyco Electronics Tooling Assistance Center at
the number at the bottom of page 1.
7. REVISION SUMMARY
Inspection of Crimping
Dies with Plug Gage
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
S Initial release of document
Figure 5
408-10032
A