91910-2 Tyco Electronics, 91910-2 Datasheet - Page 2

• Manufacturer Part Number: 91910-2
• Description: TOOL DIE SET PREMIUM COAXICON
• Manufacturer: Tyco Electronics
• Series: Pro-Crimper III, Coaxicon™r

Specifications of 91910-2

• Connector Type: Crimp Terminals
• Crimp Handle: A9996-ND
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Crimp Or Cable Size: -

4. CRIMPING PROCEDURE
4.1. Crimp the Center Contact (Refer to Figure 2)
2
SDE Crimping Die Assemblies 91902-1, 91907-[ ], 91908-1, 91909-1, 91910-[ ], and 1424050-1
Smallest Crimping
Chamber of
Anvil Die
of 4
9. To remove the die assembly from the tool frame,
close the tool handles until the ratchet releases,
remove the two die retaining screws and four die
retaining pins, and slide the dies out of the jaws.
NOTE
NOTE
1. Close the tool handles until the die assembly is
partially closed.
2. Assemble the center contact onto the center
conductor of the cable, and place the center
contact on the anvil in the smallest crimping
chamber. Make sure the flange on the end of the
center contact butts against the die.
3. Holding the cable in place, close the tool
handles until the ratchet releases.
4. Allow the tool handles to open fully and remove
the crimped center contact from the dies.
i
i
Flange of Center
Contact Butts
Against Die
Refer to the instructions included with the
connector for cable preparation and connector
assembly. Before proceeding, ensure that the
ferrule is on the cable and the braided shield is
flared away from the cable.
This tool frame has a crimp height adjustment
feature. Initially, the crimp height should be
verified. Make a sample crimp. Refer to the
instructions included with the connector for the
acceptable crimp height. If the crimp height is
unacceptable, refer to Section 5 to adjust the
crimp height.
Cable
Crimping Center Contact
Tyco Electronics Corporation
Figure 2
4.2. Crimp the Ferrule (Refer to Figure 3)
CAUTION
1. Insert the crimped center contact into the
connector body until the cable dielectric butts
against the dielectric inside the connector body or
until the center contact is securely positioned
within the connector. Make sure that the braided
shield of the cable is over the support sleeve of the
connector body and that no strands from the shield
enter the connector body.
2. Slide the ferrule over the braided shield and
onto the connector until the ferrule butts against
the shoulder of the connector body.
3. Place the ferrule in the appropriate crimping
chamber of the anvil die so that the shoulder of the
connector body butts against the edge of the die.
NOTE
4. While holding the assembly together, close the
tool handles until the dies have closed enough to
secure the assembly in place.
5. Carefully close the tool handles until the ratchet
releases, then allow the tool handles to open fully,
and remove the crimped connector from the dies.
i
!
Refer to the instructions included with the
connector to determine the appropriate crimping
chamber.
Make sure that both sides of the ferrule are
started evenly into the crimping chamber. DO
NOT attempt to crimp an improperly positioned
ferrule.
Plug Center
Contact
Jack Center
Contact
Cross-Section View
Flange
Die
Flange
Die
408-8580
Rev
B