58062-1 Tyco Electronics, 58062-1 Datasheet - Page 3

• Manufacturer Part Number: 58062-1
• Description: HEAD ASSEMBLY TOOL FOR AMP MT CO
• Manufacturer: Tyco Electronics
• Series: AMPMODU® MTr
• Type: Terminating Head for AMPMODU MT Connectorsr

Specifications of 58062-1

• Connector Type: Receptacle
• Crimp Handle: A2031-ND, 58075-1-ND, 58338-1-ND, 931800-1-ND
• Crimp Or Cable Size: 20-30 AWG
• Crimp Application: Connectors
• Product: Tool Component
• For Use With: 58075-1 - TOOL HANDLE PNEUMATIC W/O HEAD931800-1 - ELEC PWR UNIT W/O F/TRK OR HD58338-1 - PWR BENCH ASSEMBLY W/O HEADS104305-4 - CONN RCPT 8POS DL IDC .100 GOLD104305-2 - CONN RCPT 34POS DL IDC .100 GOLD104305-1 - CONN RCPT 10POS DL IDC .100 GOLD
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Lead Free Status / RoHS Status: na, Not applicable / Not applicable
• Other names: A2040

B. Manual and Electric Power Units
Rev B
Head During Termination
AMPMODU MT
Receptacle Connector
Damaged Housing—
Tight or Too Loose in
Connector Was Too
1. Remove the head from the power unit according
to the instructions packaged with the power unit.
Make sure to observe any cautions and dangers.
2. Turn the adjuster one--sixth of a revolution
clockwise if the wire is too deep in the contact, and
counterclockwise if the wire is not deep enough in
the contact. Refer to Figure 5. This will decrease or
increase the wire insertion depth by approximately
0.20 [.008].
3. Install the head onto the power unit according to
the instructions packaged with the power unit.
Make sure to observe any cautions and dangers.
Wire Was Not Inserted
Deep Enough During
[.020]
0.51
Min
Termination
A
Correct
Arms of Insulation Support
Barrel Completely Closed
Top of Wire Conductor Below
Top of Wire Barrel Slot
A
Tyco Electronics Corporation
Termination Inspection
Wire Was Inserted With
Too Much Force During
Section A- - A
Top of Wire
Barrel Slot
Termination
Incorrect
Figure 4
Turn COUNTERCLOCKWISE
To Increase
Wire Insertion Depth
Acceptable
Wire Was Not Inserted
Wire Insertion Depth Adjustment
Straight Before
Termination
Arms of Insulation Support
Barrel Partially Closed
Figure 5
Wire Was Not Fully
Turn CLOCKWISE
To Decrease
Wire Insertion Depth
Inserted Before
Adjuster
Termination
3 of 5