11-01-0204 Molex Inc, 11-01-0204 Datasheet - Page 3

• Manufacturer Part Number: 11-01-0204
• Description: TOOL HAND CRIMP 2MM CONTACTS
• Manufacturer: Molex Inc
• Series: Milli-Grid™r

Specifications of 11-01-0204

• Tool Type: Hand Crimper
• Features: Side Entry, Ratchet
• For Use With/related Products: Rectangular Contacts, 24-30 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 0011-01-0204; 0011-01-0204-E; 0011010204; 0011010204-E; 11-01-0204-E; 11010204; 11010204-E; CR60927A; WM18057

Hand Crimp Tool for Milli-Grid™ Crimp Terminal
Doc No: ATS-011010204
Revision: E
Maintenance
It is recommended that each operator of the tool be made aware of, and responsible for, the following
maintenance steps:
1. Remove dust, moisture, and other contaminants with a clean brush, or soft, lint free cloth.
2. Do not use any abrasive materials that could damage the tool.
3. Make certain all pins; pivot points and bearing surfaces are protected with a thin coat of high quality
4. When tool is not in use, keep the handles closed to prevent objects from becoming lodged in the crimping
Miscrimps or Jams
Should this tool ever become stuck or jammed in a partially closed position,
closed. The tool will open easily by lifting the ratchet release lever. See Figure 3.
How to Adjust Tool Crimp Force
See Figure 3
It may be necessary over the life of the tool to adjust tool-crimping force. Listed below are the steps required to
adjust the crimping force of the hand tool to obtain proper crimp conditions:
1. Remove the screw and washer. Located over the adjustment ring.
2. Lift the adjusting ring slightly, off of the locating pin.
3. Turn the adjusting ring in the desired direction (L= less force, T= more force) to increase or decrease crimp
4. Press the adjusting wheel flat against the tool and engage the locking pin.
5. Replace the washer and screw.
6. Check the crimp specifications after tool crimp force is adjusted.
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long life tested. All tools are warranted to be free of manufacturing defects for a period of 30
days. Should such a defect occur, we would exchange the tool free of charge. This will not be applicable to
altered, misused, or damaged tools. This tool is designed for hand use only. Any clamping, fixturing, or use of
handle extensions voids this warranty.
Hand held crimping tools are intended for low volume, prototyping, or repair requirements only.
machine oil. Do not oil excessively.
dies, and store the tool in a clean, dry area.
pressure.
Release Date: 03-02-93
Revision Date: 04-14-08
Caution: Repetitive use of this tool should be avoided.
UNCONTROLLED COPY
Do Not force the handles open or
Page 3 of 5