63811-6800 Molex Inc, 63811-6800 Datasheet - Page 3

• Manufacturer Part Number: 63811-6800
• Description: TOOL CRIMP FOR .084 CONTACTS
• Manufacturer: Molex Inc
• Series: PremiumGrade™, MLX™r
• Type: Crimp Toolr

Specifications of 63811-6800

• Tool Type: Hand Crimper
• Features: Side Entry, Ratchet
• Product: Crimping, Stripping & Cutting Tools & Drills
• Crimp Size: 20AWG To 14AWG
• Crimp Application: Contacts
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Rectangular Contacts, 14-20 AWG
• For Use With: WM1271CT - CONN TERM FEMALE 14-20AWG TINWM1271TR - CONN TERM FEMALE 14-20AWG TINWM1271 - CONN TERM FEMALE 14-20AWG TINWM1270 - CONN TERM MALE 14-20AWG TIN
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 063811-6800; 063811-6800-P; 0638116800; 0638116800-P; 63811-6800-P; 638116800; 638116800-P; WM9009

Hand Crimp Tool for MLX™ Pin and Socket Crimp Terminals
Doc No: ATS-638116800
Revision: B
6. Remove the crimped terminal from the terminal locator by pressing
7. Visually inspect the crimped terminal for proper crimp location.
Note:
A crimp height chart is provided with this manual as Reference Only.
Due to the wide range of wires, strands, insulation diameters, and
durometers, actual crimp height measurements may very slightly. An
occasional, destructive, pull force test should be preformed to check
hand tool crimp. Pull Force value Must exceed the Minimum pull force
specifications listed on page 2.
Locator Replacement
See the parts list on the last page of this document for the
proper locator order number. Follow the steps below to
replace the locator.
1. Open the crimp hand tool.
2. Swing the existing locator open and away from the
3. Firmly press down on the brass pivot shaft with your
4. Replace it with the desired locator by putting over the
down on the wire stop and gently pulling on the wire. The terminal
locator can be in either position.
hand tool.
thumb, while pulling the locator up. Slip the locator off
the top of the brass pivot shaft. See Figure 4.
brass pivot shaft and snapping it into place.
TOOPEN WIRE
PUSH HERE
STOP
LOCATOR
Release Date: 09-18-06
Revision Date: 03-28-08
SWING OPEN
TERMINAL
Figure 2
LOCATOR
TERMINAL
IN PLACE
UNCONTROLLED COPY
LOCATOR
SWING
OPEN
PRESS DOWN
PIVOT SHAFT
ON BRASS
LOCATOR
IN PLACE
WIRE STOP
WIRE AGAINST
WIRE STOP
STOP
LIFT UP LOCATOR
Figure 3
Figure 4
JAWS OPEN
Page 3 of 6
TERMINAL
WIRE