FLUKE-66 Fluke Electronics, FLUKE-66 Datasheet - Page 23

• Manufacturer Part Number: FLUKE-66
• Description: THERMOMETER IR ADJ -25 TO 1100F
• Manufacturer: Fluke Electronics
• Series: 60r
• Type: Handheld, Gunr

Specifications of FLUKE-66

• Temperature Range: -25 ~ 1100°F (-32 ~ 600°C)
• Temperature Display: C°/F°
• Display Type: LCD
• Input Type: Infrared; Probe
• Features: Alarm, Backlight, Hold, Laser Sight, Memory, MIN/MAX/Dif/Avg
• Probe Type: RTD
• Battery Type: 9 Volt
• Includes: Case
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 2148296; 614-1040

63/66/68
Operating the Thermometer
HOLD
The unit’s display will remain activated for seven seconds after the
trigger is released, unless the unit is locked on (lock on 66/68 only).
HOLD appears in the upper left of the display. During HOLD or
after the unit shuts off, recall stored values by pressing
without
pulling the trigger (66/68). Each time
is pressed, the unit
advances through the function cycle. When the trigger is pulled
again, the unit will begin measuring in the last function selected.
Storing Data (66/68)
The thermometers are capable of storing up to 12 data locations.
The infrared temperature, temperature scale
( C or F), and emissivity are also stored.
To store data from an infrared reading, pull the trigger. While
holding the trigger, press
until LOG appears in the lower left of
the display. A log location number is shown below LOG. If no
temperature has been recorded in the shown LOG location, 3
dashes will appear in the lower right corner. Aim the unit at the
desired target and press
. A tone confirms that the location
temperature has been recorded. The recorded temperature
appears in the lower right corner of the display. To select another
log location, press
or
.
Recalling Data (66/68)
Recall stored data after the unit shuts off by pressing
until LOG
appears in the display’s lower left corner. A LOG location is shown
below LOG and the stored temperature for that location will be
shown in the display’s lower right corner. To move to another LOG
location, press
or
.
LOG Clear Function
The LOG Clear function allows you to quickly clear all logged data
points. This function can only be used when the unit is in LOG
mode. It can be used when the thermometer has any number of log
locations stored.
19