XH414H-II06E Seiko Instruments, XH414H-II06E Datasheet - Page 11

• Manufacturer Part Number: XH414H-II06E
• Description: CAP DOUBLE LAYER ELEC .07F 3.3V
• Manufacturer: Seiko Instruments
• Series: XHr

Specifications of XH414H-II06E

• Capacitance: 70mF
• Voltage - Rated: 3.3V
• Mounting Type: Surface Mount
• Package / Case: Surface Mount - Coin Style
• Height: 0.055" (1.40mm)
• Size / Dimension: 0.189" Dia (4.80mm)
• Operating Temperature: -25°C ~ 70°C
• Voltage Rating: 3.3 Volts
• Operating Temperature Range: - 25 C to + 70 C
• Dimensions: 4.8 mm Dia. x 1.4 mm L x 1.4 mm H
• Product: Super Capacitors
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Tolerance: -
• Lead Spacing: -
• Esr (equivalent Series Resistance): -
• Lifetime @ Temp.: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 728-1037-2

10. Inspection (Outgoing and Incoming)
11. Package specifications
12. In case of quality trouble
13. Operation of this Specification
10-1. Lot composition
10-2. Outgoing Inspection
10-3. Incoming Inspection
11-1. Wrapping
11-2. Wrapping and packing
The warranties set forth herein are the only warranties on the Products.
The liabilities of SII Micro Parts Ltd. in connection with the Products under these
specifications are expressly limited to the replacement of defective Products.
13-1. Agreement
13-2. Negotiation
SII Micro Parts Ltd., shall do outgoing inspection before shipping. The inspection items
are as below table. The inspection results shall be submitted immediately for the
customer request.
The customer should do incoming inspection within 30 days from the receiving day.
If defects are find out at the incoming inspection, the customer immediately should
notify to SII Micro Parts Ltd. in writing, with the defective products, for replacement
request. When there was no connection from you within 30 days, we shall judge that
those were accepted.
Lot must be composed within the same manufacturing conditions.
Examples of the tray etc. for wrapping, wrapping specification, and packing
specification are shown in the following.
Before these specifications being revised, the agreement, of the customer, seller and
manufacturer, is required.
If some accident not specified on these specifications occurs, the customer, seller
and manufacturer must negotiate in order to solve the problem faithfully.
Refer to “Drawing of Emboss Carrier Tape” and “Taping specifications”.
Refer to “Package Specifications”.
No
1
2
3
Internal Impedance (initial)
Leakage Resistance
Capacity (initial)
Characteristics
P.11/12
Inspection levels
n=10, c=0
n=6, c=0
n=6, c=0
STDE-B-XH0414H02RII06E-0010-1
Frequency
per lot
per lot
per lot