LAA127 Clare, LAA127 Datasheet - Page 5

• Manufacturer Part Number: LAA127
• Description: RELAY OPTO 2 CHANNEL NO/NO 8-DIP
• Manufacturer: Clare
• Series: LAA, OptoMOS®r

Specifications of LAA127

• Circuit: DPST (2 Form A)
• Output Type: AC, DC
• On-state Resistance: 10 Ohm
• Load Current: 200mA
• Voltage - Input: 1.2VDC
• Voltage - Load: 0 ~ 250 V
• Mounting Type: Through Hole
• Termination Style: PC Pin
• Package / Case: 8-DIP (0.300", 7.62mm)
• Input Type: DC
• Input Voltage (max): 1.4V
• Output Voltage (max): 250V
• Input Current (max): 50mA
• Output Current: 200mA
• Isolation Voltage: 3750(RMS)V
• Circuit Arrangement: 2 Form A
• Package Type: PDIP
• Output Device: MOSFET
• Pin Count: 8
• Mounting: Through Hole
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Rad Hardened: No
• Load Voltage Rating: 250 V
• Load Current Rating: 170 mA
• Contact Form: 1 Form A
• Mounting Style: PCB
• Relay Type: Dual Pole
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: CLA172

R10
Manufacturing Information
Moisture Sensitivity
the maximum conditions set forth in the standard, and guarantee proper operation of our devices when handled
according to the limitations and information in that standard as well as to any limitations set forth in the information or
standards referenced below.
Failure to adhere to the warnings or limitations as established by the listed specifications could result in reduced
product performance, reduction of operable life, and/or reduction of overall reliability.
This product carries a Moisture Sensitivity Level (MSL) rating as shown below, and should be handled according
to the requirements of the latest version of the joint industry standard IPC/JEDEC J-STD-033.
ESD Sensitivity
Reflow Profile
This product has a maximum body temperature and time rating as shown below. All other guidelines of J-STD-020
must be observed.
Board Wash
Clare recommends the use of no-clean flux formulations. However, board washing to remove flux residue is acceptable.
Since Clare employs the use of silicone coating as an optical waveguide in many of its optically isolated products,
the use of a short drying bake may be necessary if a wash is used after solder reflow processes. Chlorine-based or
Fluorine-based solvents or fluxes should not be used. Cleaning methods that employ ultrasonic energy should not be
used.
Pb
All plastic encapsulated semiconductor packages are susceptible to moisture ingression. Clare classified all
of its plastic encapsulated devices for moisture sensitivity according to the latest version of the joint industry
standard, IPC/JEDEC J-STD-020, in force at the time of product evaluation. We test all of our products to
This product is ESD Sensitive, and should be handled according to the industry standard JESD-625.
2002/95/EC
RoHS
LAA127 / LAA127S / LAA127P
e
3
LAA127 / LAA127S
LAA127P
Device
Device
www.clare.com
Moisture Sensitivity Level (MSL) Rating
Maximum Temperature x Time
250ºC for 30 seconds
260ºC for 30 seconds
MSL 1
LAA127
5