G2R-1-SN AC110(S) Omron, G2R-1-SN AC110(S) Datasheet - Page 28

• Manufacturer Part Number: G2R-1-SN AC110(S)
• Description: RELAY SPDT 110VAC PLUG-IN W/LED
• Manufacturer: Omron
• Series: G2RSr

Specifications of G2R-1-SN AC110(S)

• Relay Type: General Purpose
• Contact Form: SPDT (1 Form C)
• Contact Rating (current): 10A
• Switching Voltage: 440VAC, 125VDC - Max
• Coil Type: Standard
• Coil Current: 8.2mA
• Coil Voltage: 110VAC
• Turn On Voltage (max): 88 VAC
• Turn Off Voltage (min): 33 VAC
• Mounting Type: Socket
• Termination Style: Quick Connect - .187" (4.7mm)
• Circuit: SPDT (1 Form C)
• Contact Rating @ Voltage: 10A @ 250VAC
• Control On Voltage (max): 88 VAC
• Control Off Voltage (min): 33 VAC
• Contact Rating: 10 A
• Contact Termination: Pin
• Mounting Style: Plug-In
• Power Consumption: 0.9 VA
• Contact Material: Silver Alloy
• Coil Resistance: 5.566 K Ohms
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: G2R-1-SNAC110(S); G2R1SNAC110S

Determining Rb
The current flows into Rb should be enough to turn ON TR when the
relay is reset. When determining value of Rb, the following points
must be noted:
• TR must be sufficiently turned ON even when T equals the time
• Give adequate consideration to changes in the due to changes in
An experiment reveals that the relay sufficiently operates with a
capacitance of 100 μF + 47 μF where the relay is rated at a supply
voltage of 5 VDC and a coil voltage of 3 VDC. It can therefore be said
that the capacitance can be lower than the calculated value. This is
because the time constant is determined with a relatively wide mar-
gin. So it is recommended to perform experiments to determine the
time constant.
28
constant.
ambient temperature. Simple as it is, the driver circuit introduced
here can efficiently control the relay, consuming a tiny amount of
power.
Electromechanical Relays
Technical Information
Application circuit example
The TTL output of a solid-state switch can be used as Q
Half-wave rectified AC power is applied to the circuit. Q
of a TTL, and drives the relay.
1
2
is the output
.