PTC-04-90316 Melexis Inc, PTC-04-90316 Datasheet - Page 9

• Manufacturer Part Number: PTC-04-90316
• Description: PROGRAMMER FOR HALL EFFECT 90316
• Manufacturer: Melexis Inc
• Type: Programmable Linear Hall Effect Sensorsr

Specifications of PTC-04-90316

• Contents: Programmer, Software, Cables and Documentation
• For Use With/related Products: MLX90316
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

7. Main Board description
7.1. Board Layout
Figure 7-1
As shown in
Beside these four areas, there are the input connector on the main board and the two connectors to the
daughter board.
7.2. Power Supplies
The Power Supply input connector is a single input to supply the whole PTC. The Input supply requires a
minimum of 24 volts and can tolerate a maximum of 48 volts. It is not recommended to use a higher
voltage than needed for the application. There’s an internal fuse (on the main board) of 1 A in order to
avoid damage when improperly used. The connected supply should provide a minimum current of 1.5 A
with peak capacity to source 10A.
The external Supply is the source to create all the internal requirements. Internal voltages are created on
the main board by using the input voltage from the external supply.
3901290014501
Rev. 1.5
•
•
•
•
•
•
•
•
The Supplies where all required voltage and current levels are created
The digital Core that processes all requests from the host computer
A Driver Area where the Programmable Power supplies are located
A Measurement area where the ADC and the input MUX are located
+35V for drivers (for the drivers or Programmable Power Supplies)
+5V Digital
+5V Analog
+3.3 V Digital
Figure 7-1
, The Main board can be divided in 4 major areas.
(Digital core as interface between PTC and Host application)
(measurement circuit with MUX and ADC)
(Supply for the FPGA and USB)
Page 9 of 18
Programmer for Melexis PTC devices
Data Sheet PTC04
PTC04
May 10