DEMO9S08QG8 Freescale Semiconductor, DEMO9S08QG8 Datasheet - Page 17

• Manufacturer Part Number: DEMO9S08QG8
• Description: BOARD EVAL FOR MC9S08QG4/8
• Manufacturer: Freescale Semiconductor

Specifications of DEMO9S08QG8

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

from the USB bus; therefore, total current consumption for the target board, and all connected
circuitry, must not exceed 500mA. Excessive current drain will violate the USB specification
causing the USB bus to disconnect; power is removed from the target forcing a POR.
BDM_PORT Header
An HCS08/HC(S)12 BDM cable may be attached to a 6-pin BDM_PORT port header.
However, this header is not installed in default configuration. Use of this port requires the user
to install a 2x3, 0.1” center, pin header. Refer to the BDM cable documentation for details on
the use of the BDM cable. The BDM_PORT header pin-out is shown below.
Figure 6: BDM Port
Freescale Semiconductor
NOTE: This header is not installed in default configuration.
CAUTION: Violating the USB specification will cause the USB bus to disconnect forcing the
PTA4/ BKGD
target to reset.
1
3
5
2
4
6
GND
PTA5/RESET*
VDD
See the HCS08 Device User Guide for
complete BDM_PORT documentation
17