HS2168KCM01H Renesas Electronics America, HS2168KCM01H Datasheet
HS2168KCM01H
Specifications of HS2168KCM01H
Related parts for HS2168KCM01H
HS2168KCM01H Summary of contents
Page 1
To our customers, Old Company Name in Catalogs and Other Documents st On April 1 , 2010, NEC Electronics Corporation merged with Renesas Technology Corporation, and Renesas Electronics Corporation took over all the business of both companies. Therefore, although the ...
Page 2
All information included in this document is current as of the date this document is issued. Such information, however, is subject to change without any prior notice. Before purchasing or using any Renesas Electronics products listed herein, please confirm ...
Page 3
...
Page 4
... Connection of H8S/2168F with E10A Emulator User’s Manual HS2168KCM01H HS2168KCI01H with User System www.renesas-electoronics.com Version 1.00 ...
Page 5
Connecting the E10A Emulator with the User system Before connecting an E10A emulator (hereafter referred to as emulator) with the user system, a connector must be installed in the user system so that an user I/F cable can be ...
Page 6
Installation of Connector in the User System Table 2.1 shows the Hitachi-UDI port connector for the emulator. Table 2.1 Recommended Connector Type Number Manufacturer 2514-6002xx* 3M Limited Note: xx means plated version. Note: When the connector is used, do ...
Page 7
Pin Arrangement of the H-UDI Port Connector Figure 3.1 shows the pin arrangement of the Hitachi-UDI port connector. Figure 3.1 Pin Arrangement of the Hitachi-UDI Port Connector 4 ...
Page 8
Example of Emulator Connection The following shows an example of connecting the user system to the emulator. Figure 4.1 Example of Emulator Connection 5 ...
Page 9
Notes ETRST, ETCK, ETMS, ETD0, and ETDI are used by the emulator for H8S/2168F. Pull up and connect the emulator and MCU pins. Figure 4.2 Connection of Emulator and MCU 6 ...
Page 10
Pin #MD2 of the H8S/2168F must be pulled up before connecting the emulator to the user system. If the emulator is not connected to the user system, ground pin #MD2. Figure 4.3 E10A Emulator and #MD2 Pin 7 ...
Page 11
Hitachi-UDI port connector is a signal line in which the emulator outputs signals to the MCU. An AND operation must be performed between #RES (pin 7) and the user system reset circuit for ...
Page 12
Figure 4.6 shows the interface circuit in the emulator. Use this figure as a reference when determining the pull-up resistance value. Figure 4.6 Interface Circuit in the Emulator (Reference) 9 ...