RTA-FOUSB-MON Renesas Electronics America, RTA-FOUSB-MON Datasheet - Page 20

• Manufacturer Part Number: RTA-FOUSB-MON
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Type: FLASHr

Specifications of RTA-FOUSB-MON

• Contents: USB Compact Flash Programmer, USB Cable, CD-ROM and User Manual
• For Use With/related Products: M16C Family and 740 Family
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Appendix A. ICD Board Specifications
The following table lists the specifications for the ICD Board.
RTA-FOUSB-MON User’s Manual Rev 2.2
Table A.1 ICD Specification
USB MCU
Interface
LED
Switch, Jumpers
Power Configuration
Current Requirements
Board Size
a. USB (J1)
b. UART Interface (J2)
c. Target Interface (J3)
a. Red (D1)
b. Red (D2)
c. Green (D3)
d. Yellow (D4)
a. Bus Power (S1)
b. MCU Mode (JP1)
c. Debug (JP3)
Item
Renesas M37641F8HP (8-bit USB Flash MCU)
PC host and target connectivity.
Full speed USB connection and USB 2.0 compliant. Primary
connection to debug PC.
4-pin header for RS-232C PC connection (TTL Level -RS-232C
transceiver/circuit is mounted externally).
10-pin connection with starter kit board or target board. Please
read ‘Target Board Connectivity’ on how to design the target
hardware to connect the ICD.
4 LED’s: 2 red, 1 green, 1 yellow
Power LED.
Lights up when target MCU is stopped.
Lights up when target MCU is running.
ICD ready status – blinking
Provide additional debug pins, microprocessor mode and power
supply selection.
Power selection: Bus powered or target powered.
CNVss pin for boot mode (shunted) or user mode (open).
Provide debug pins for external interrupts (INT0, INT1), monitor
status, counters 0 & 1 output pins.
The ICD will operate either at 5V or 3.3V and may be bus
powered (from USB) or target powered. 5V/3.3V selection using
pin 6 of J3 connection to target.
The maximum current draw by the ICD is 50mA.
2.75” x 1.15” (70mm x 29 mm)
19 / 27
Description
Applications Engineering
Jan 2005