MPC564EVB Freescale Semiconductor, MPC564EVB Datasheet - Page 43

• Manufacturer Part Number: MPC564EVB
• Description: KIT EVAL FOR MPC561/562/563/564
• Manufacturer: Freescale Semiconductor
• Type: Microcontrollerr

Specifications of MPC564EVB

• Contents: Module Board, Installation Guide, Power Supply, Cable, Software and more
• Processor To Be Evaluated: MPC56x
• Data Bus Width: 32 bit
• Interface Type: RS-232, Ethernet
• For Use With/related Products: MPC561, 562, 563, 564
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Freescale Semiconductor, Inc.
Installation And Setup
Power Oak supplies.
PWR jack connection provides power input from the supplied wall plug power source. Typical
input is +12VDC. The PWR jack provides a center positive terminal and ground outside sleeve.
The jack accepts 2.1mm inside x 5.5mm outside power plugs.
PWR Front View
TB1 Front View
2mm Center Pin, Positive Volt
GND +VIN VIGN
5.5mm Outer Ring, Ground
2.2.4 Selecting Terminal Baud Rate
The serial channel SCI0 of the MPC564 is used for serial communication and has a built in baud
rate generator. A number of baud rates can be programmed. On power-up or manual RESET, the
dBUG ROM monitor firmware configures the channel for 19200 baud. Once the dBUG ROM
monitor is running, a SET command may be issued to select any baud rate supported by the ROM
monitor. Refer to Chapter 3 for the discussion of this command.
2.2.5 The Terminal Character Format
The character format of the communication channel is fixed at power-up or RESET. The default
character format is 8 bits per character, no parity and one stop bit with no flow control. It is
neccessary to ensure that the terminal or PC is set to this format.
2.2.6 Connecting the Terminal
The board is now ready to be connected to a PC/terminal. Use the RS232 serial cable to connect
the PC/terminal to the MPC564EVB at COM-1. The cable has a 9-pin female D-sub terminal
connector at one end and a 9-pin male D-sub connector at the other end. Connect the 9-pin male
connector to connector COM-1 on the MPC564EVB board. Connect the 9-pin female connector
to one of the available serial communication channels normally referred to as COM1 (COM2, etc.)
on the PC running terminal emulation software (such as AxIDE, TeraTerm or Hyperterminal). The
connector on the PC/terminal may be either male 25-pin or 9-pin. It may be neccessary to obtain
a 25-pin-to-9-pin adapter to make this connection. If an adapter is required, refer to Figure 2-2
which shows the pin assignment for the 9-pin connector on the board.
2.2.7 Using a Personal Computer as a Terminal
A personal computer may be used as a terminal provided a terminal emulation software package is
available. Examples of this software are AxIDE, TeraTerm, PROCOMM, KERMIT, QMODEM,
Windows 95/98/2000 HyperTerminal or similar packages. The board should then be connected as
Chapter 2. Initialization and Setup
2-5
For More Information On This Product,
Go to: www.freescale.com