EVAL6599-90W STMicroelectronics, EVAL6599-90W Datasheet - Page 23

• Manufacturer Part Number: EVAL6599-90W
• Description: EVAL BOARD FOR L6599
• Manufacturer: STMicroelectronics
• Type: Power Factor Correctionr

Specifications of EVAL6599-90W

• Main Purpose: AC/DC, Primary Side and PFC
• Outputs And Type: 1, Isolated
• Power - Output: 90W
• Voltage - Output: 19V
• Current - Output: 4.7A
• Voltage - Input: 90 ~ 264VAC
• Regulator Topology: Resonant
• Frequency - Switching: 90kHz
• Board Type: Fully Populated
• Utilized Ic / Part: L6563, L6599
• Input Voltage: 90 V to 264 V
• Output Voltage: 19 V
• Dimensions: 78 mm x 174 mm
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: L6599
• Other names: 497-5497

L6563 - L6563A
6.5
Tracking Boost function
In some applications it may be advantageous to regulate the output voltage of the PFC pre-
regulator so that it tracks the RMS input voltage rather than at a fixed value like in
conventional boost pre-regulators. This is commonly referred to as "tracking boost" or
"follower boost" approach.
With this IC the function can be realized by connecting a resistor (R
and ground. The TBO pin presents a DC level equal to the peak of the MULT pin voltage and
is then representative of the mains RMS voltage. The resistor defines a current, equal to
V(TBO)/R
amplifier. In this way, when the mains voltage increases the voltage at TBO pin will increase
as well and so will do the current flowing through the resistor connected between TBO and
GND. Then a larger current will be sunk by INV pin and the output voltage of the PFC pre-
regulator will be forced to get higher. Obviously, the output voltage will move in the opposite
direction if the input voltage decreases.
To avoid undesired output voltage rise should the mains voltage exceed the maximum
specified value, the voltage at the TBO pin is clamped at 3V. By properly selecting the
multiplier bias it is possible to set the maximum input voltage above which input-to-output
tracking ends and the output voltage becomes constant. If this function is not used, leave
the pin open: the device will regulate a fixed output voltage.
Starting from the following data:
●
●
●
●
●
●
Vin
Vin
Vo
Vo
Vox = absolute maximum limit for the regulated output voltage;
∆Vo = OVP threshold,
1
2
1
2
= regulated output voltage @ Vin = Vin
= regulated output voltage @ Vin = Vin
= minimum specified input RMS voltage;
= maximum specified input RMS voltage;
T
, that is internally 1:1 mirrored and sunk from pin INV (pin 1) input of the error
1
2
;
;
Application information
T
) between the TBO pin
23/39