ST7MDT20-EVC/US STMicroelectronics, ST7MDT20-EVC/US Datasheet - Page 16
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
ST7MDT20-EVC/US
Manufacturer Part Number
ST7MDT20-EVC/US
Description
BOARD EVALUATION/TRAINING/PROGRM
Manufacturer
STMicroelectronics
Datasheet
1.ST7MDT20-EVCUS.pdf
(33 pages)
Specifications of ST7MDT20-EVC/US
Module/board Type
Evaluation Board
For Use With/related Products
ST72124,7231x,72321,72334,72511,72512,72521
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Other names
497-2897
ST7 MDT20 EVAL BOARD DESCRIPTION
1.10.3 Jumper J5 - SCI Enable/Disable
In order to use the SCI peripheral device, these 2 jumpers must be connected; otherwise, it is
recommended that they be removed from the board. Please refer to
Figure 4.
1.10.4 Jumper J6 - MCU Voltage Supply
This jumper is dedicated to the MCU power supply only. When it is removed, it can be used,
for example, to measure the current consumption of the MCU by connecting a DC-ammeter in
parallel.
1.10.5 Jumper J7 - Buzzer Enable/Disable
This jumper enables the buzzer to be used once it is connected to pin PF1.
1.10.6 Jumpers J9, J10, J11 - LED Enable/Disable
These 3 jumpers are used to connect the three LEDs (D5, D6 and D7) to pins PB5, PB6 and
PB7. It is recommended that the jumpers be removed from the board if this feature is not used.
1.10.7 ISP Connector
Please refer to
Section
1.7.
1.10.8 NMI Pull-down/Pull-up
A pull-down (or, pull-up) is applied on pin NMI if a jumper is connected between pins 2-3 (or,
pins 1-2) on the board.
16/33