M32100T2-SDI-E Renesas Electronics America, M32100T2-SDI-E Datasheet - Page 43

• Manufacturer Part Number: M32100T2-SDI-E
• Description: DEV SDI EMULATOR FOR M32R/ECU SE
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M32100T2-SDI-E

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32R Family
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4.2 Downloading Firmware
4.3 Self-check
(1) When It is Necessary to Download Firmware
It is necessary to download the firmware in the occasions below. Generally, these are detected when
the emulator debugger starting up, then downloading the firmware is started.
Redownload the firmware when the power supply is shut off or when the communication interface
cable is pulled out while downloading the firmware from the emulator debugger, following the
procedure below.
(2) Downloading Firmware in Maintenance Mode
Download the firmware in maintenance mode as explained here following.
For the self-check procedure, refer to "3.3 Self-check Procedure" (page 34).
Note on Downloading Firmware:
(1) When you use this product for the first time
(2) When the firmware has been upgraded
(3) When the emulator debugger has been upgraded
(1) Within 2 seconds of activating power to the emulator, press the system reset switch on the
(2) Start up the emulator debugger. When the Init dialog box setup is completed, the dialog which
emulator front panel. This will switch the emulator to maintenance mode.
When switching to maintenance mode, "SAFE" of SYSTEM STATUS LED blinks.
prompts for downloading the firmware will appear. Download the firmware following the
messages. It takes about 30 seconds for downloading the firmware.
• Do not shut OFF power while the firmware is being downloaded. Doing so, the
emulator will not start up properly. If power is shut OFF by mistake, redownload the
firmware in maintenance mode.
( 41 / 54 )
IMPORTANT