M32100T2-SDI-E Renesas Electronics America, M32100T2-SDI-E Datasheet - Page 15

• Manufacturer Part Number: M32100T2-SDI-E
• Description: DEV SDI EMULATOR FOR M32R/ECU SE
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of M32100T2-SDI-E

• Contents: Compact Emulator, IDE, Assembler and Linker
• For Use With/related Products: M32R Family
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Note on Specifying Breakpoints:
Note on Specifying Hardware Breakpoint:
Note on RESET Control Switch:
Note on Using Reset Mask:
Note on Access Prohibited Areas:
• Due to the MCU's architecture, the following addresses cannot be set as a breakpoint.
• Do not set a hardware breakpoint for instruction execution at address 0x0. This is because if a
• When the RESET control switch on the probe is set to Hiz START, the following operation allows
• If the reset signal from the target board is masked (disabled) using the script command (ResetMask)
• The emulator uses the address area H'FFFF 8000 to H'FFFF 9FFF of the target MCU as the
By resetting only peripheral circuits, problems will occur such as target MCU bus cycles not
hardware breakpoint is set at address 0x0, the target program cannot be run. If a breakpoint at
address 0x0 is desired, set a software breakpoint, preexecution PC breakpoint, or postexecution PC
breakpoint.
you to execute the program from the reset vector during time from (2) to (3).
of the emulator debugger, the reset signal that is input to the target MCU while the target program
is running will be ignored and the target MCU will not be reset.
completing, and the target MCU may runaway.
dedicated area for the emulator. When accessing to this area from the target program, the operation
of the emulator cannot be supported. Therefore, do not access to this area from the target program.
(1) Addresses (4n + 2) in the middle of a 1-word instruction
(2) Addresses (4n + 2) in the instruction located in word align + 2 addresses, which are executed
(1) Turn ON the emulator power switch.
(2) Press the system reset switch on the emulator after the emulator gets started.
(3) Start the emulator debugger M3T-PD32R.
in parallel
This phenomenon occurs immediately after the emulator starts only.
IMPORTANT
( 13 / 54 )