R0E5212BACPE00 Renesas Electronics America, R0E5212BACPE00 Datasheet - Page 22

• Manufacturer Part Number: R0E5212BACPE00
• Description: EMULATOR COMPACT/CONV BRD R8C/2B
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of R0E5212BACPE00

• Contents: Compact Emulator, IDE, Assembler and Linker
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• For Use With/related Products: R8C/2A, R8C/2B
• Lead Free Status / RoHS Status: Supplier Unconfirmed, Contains lead / RoHS non-compliant

R0E521000CPE00 User’s Manual
2. Setup
This chapter describes the preparation for using this product, the procedure for starting up the emulator and how to change
settings.
2.1 Flowchart of Starting Up the Emulator
The procedure for starting up the emulator is shown in Figure 2.1. For details, refer to each section hereafter. And, when the
emulator does not start up normally, refer to “5. Troubleshooting” (page 84).
Figure 2.1 Flowchart of starting up the emulator
REJ10J0845-0600 Rev.6.00 Aug. 20, 2009
Page 20 of 92
Connect the power supply for the emulator.
Debug a program with various functions of
High-performance Embedded Workshop.
Start up the emulator debugger form the
Check the LED display of the emulator.
Connect the USB interface cable.
Check the package components.
Set the operating environment
Turning on the power supply.
Install the included software.
of the emulator debugger.
Connect the user system.
the emulator debugger.
Changing settings.
User registration
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
Refer to “1.1 Package Components” (page 14).
Refer to “User Registration” (page 12).
Install it from the included CD-ROM.
Select a power voltage supplied to the target MCU or clock supply
according to conditions of use.
Connect the USB interface cable to the USB interface connector
(J2) of the emulator and the USB port of the host machine.
Connect a power supply to the power connector (J1). Power supply
should be 5.0 V ±5%, 2 A.
Connect the user system as occasion demands.
Turn on the power to the emulator and the user system as
simultaneously as possible.
Check that the system status LED, and POWER and RESET of
target status LED are lighting. When the user system is not
connected, the POWER LED does not light up.
Start up the High-performance Embedded Workshop and the
emulator debugger.
Set the INIT dialog box and MCU Setting dialog box of the
emulator debugger.
For how to use the emulator debugger, refer to the online manual of
the
debugger.
High-performance
Embedded
Workshop
and
emulator
2. Setup