ST62GP-EMU2 STMicroelectronics, ST62GP-EMU2 Datasheet - Page 47

• Manufacturer Part Number: ST62GP-EMU2
• Description: KIT EMULATOR FOR ST6 MCU SER
• Manufacturer: STMicroelectronics
• Series: ST6-EMU2r
• Type: Microcontrollerr

Specifications of ST62GP-EMU2

• Contents: Emulator, Set of Probes, Power Supply, Parallel Cable, and ST6-RIDE Software
• For Use With/related Products: ST62x
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST62GP-EMU2 Emulator User Manual
APPENDIX A:TROUBLESHOOTING
A.1
1
2
3
4
5
6
7
8
The power status LED on the
ST62GP-EMU2 front panel is off.
The Run status LED does not
switch on when you start your pro-
gram.
WGDB6 crashes.
Error message:
-hds2 -lpt1 timeout during synchro-
nization
Error message:
Check if the emulator is switched on
and if the parallel cable is well con-
nected.
Error message:
No message received from the
emulator.
Error message:
This action is forbidden while the
emulator is running.
Error message:
Error FS_TargetReadonly.
Identifying the Problem
IF.....
Check the power cable connections. Check the power
switch on the ST62GP-EMU2 back panel.
Check the title bar of the WGDB6 main window, you may
be in WGDB6 Simulator instead of WGDB6 Emulator.
Remove the wgdb6win.ini from the C:\Windows directory
and the filename.wsd file from the working directory.
If this does not solve the problem, save any work files,
delete the directory
c:\Program Files\Stm\St6toolchain\soft
and re-install WGDB6.
Check that the ST62GP-EMU2 is connected to LPT1
and check if the power supply is on.
This message is also displayed when there is a configu-
ration mismatch. Configure the parallel port of your PC,
referring to
on page 48. If the problem persists, save any work files,
delete the directory
c:\Program Files\Stm\St6toolchain\soft
and re-install WGDB6.
Check that the ST62GP-EMU2 is powered on, and that
the emulator boards are fully inserted in their slots.
Close WGDB6 and restart Windows.
This message can occur if WGDB6 is installed over an
existing version. To correct this problem, save any work
files, then delete the directory
c:\Program Files\Stm\St6toolchain\soft
before reinstalling WGDB6.
Changing the Parallel Port Setup on Your PC
.... THEN
Appendix A: Troubleshooting
47/57