EPSILON5-A1 Equinox Technologies, EPSILON5-A1 Datasheet - Page 53

ISP PORTABLE PROGRAMMER USB

EPSILON5-A1

Manufacturer Part Number
EPSILON5-A1
Description
ISP PORTABLE PROGRAMMER USB
Manufacturer
Equinox Technologies
Series
Epsilon5r
Type
Portable ISPr
Datasheets

Specifications of EPSILON5-A1

Contents
Programmer, Software, Cables and Documentation
Ic Product Type
In-Circuit Programmer
Features
2Mbits Of On-Board Non-Volatile FLASH Memory For User Project Storage
Interface Type
JTAG
Mcu Supported Families
ATmega And AT91SAM7
Mpu Supported Families
AVR
Rohs Compliant
Yes
External Depth
31mm
Height
189mm
Length
80mm
For Use With/related Products
ATMEL AT89S, AVR, AT91SAM7, NXP P89C51Rx2 P89C66x, Zensys, Serial EEPROM's
Other names
483-1000
3.4 Programmer Powers the Target System
3.4.1 Overview
In this scenario, the programmer is constantly powered from an external power supply (not supplied)
via the connector CON1. The Jumper J9 is fitted which connects the voltage applied to CON1 to the
PROG_VCC pin on each ISP header. The external power supply voltage V_EXT_PSU is therefore
routed directly to the Target System Vcc. When an ISP Cable is connected from the programmer to
a Target System, the Target System will power up to the external power supply voltage V_EXT_PSU.
When the cable is removed, the Target System will power off.
3.4.2 Hardware Setup - Programmer powers the Target System
DC Power Cable
The programmer is supplied with a ‘DC Power Cable’ which plugs into the CON1 - DC Power Input
Connector on the programmer.
42
The black lead with the white stripe is the +VE cable.
The all black lead is the GROUND cable.
The external voltage applied to CON1 must be between 3.1 and 5.0V !
The Target System must not draw more than 300 mA from the programmer.
EPSILON5 MKII Programmer - User Guide V1.12 – 1
st
August 2007

Related parts for EPSILON5-A1