DSP56F800DEMO-E Freescale Semiconductor, DSP56F800DEMO-E Datasheet - Page 11

• Manufacturer Part Number: DSP56F800DEMO-E
• Description: KIT EVAL FOR DSP56F800 W/UPS
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of DSP56F800DEMO-E

• Contents: Module Board, Installation Guide, Power Supply, Cable, Software and more
• Processor To Be Evaluated: 56F80x
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Operating Supply Voltage: 9 V
• Silicon Manufacturer: Freescale
• Core Architecture: 56800/E
• Core Sub-architecture: 56800/E
• Silicon Core Number: MC56F
• Silicon Family Name: MC56F80xx
• Kit Contents: Demo Board, Cables, CD & Documents
• Rohs Compliant: No
• For Use With/related Products: DSP56F800
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Freescale Semiconductor
Cautionary Notes
Terminology
This development board applies option selection jumpers. Terminology for application of
the option jumpers is as follows:
Jumper on, in, or installed = jumper is a plastic shunt that fits across 2 pins and the shunt is
installed so that the 2 pins are connected with the shunt.
Jumper off, out, or idle = jumper or shunt is installed so that only 1 pin holds the shunt, no
2 pins are connected, or jumper is removed. It is recommended that the jumpers be idled
by installing on 1 pin so they will not be lost.
This development board applies CUT_AWAY option selections. These option selections
apply surface mount resistor locations with a printed circuit board trace connecting both
component pads. This type connection places an equivalent 0-ohm type resistor in series
with the I/O signal and the user component or I/O connector on the board. These
connections maybe cut with a razor blade or similar type knife between the component
pads to isolate the default connection provided. Reconnection of the cut-away type pads
can be made by either installing a 0 ohm 0805 size surface mount resistor or a small wire
jumper on the component pads.
1. Electrostatic Discharge (ESD) prevention measures should be applied whenever
2. EMC Information on the 56F800 Demonstration Board:
handling this product. ESD damage is not a warranty repair item.
a. This product as shipped from the factory with associated power supplies and
b. This product is designed and intended for use as a development platform for
c. In a domestic environment this product may cause radio interference in which
d. Attaching additional wiring to this product or modifying the products operation
cables, has been tested and meets with requirements of CE and the FCC as a
CLASS A product.
hardware or software in an educational or professional laboratory.
case the user may be required to take adequate prevention measures.
from the factory default as shipped may effect its performance and also cause
interference with other apparatus in the immediate vicinity. If such interference
is detected, suitable mitigating measures should be taken.
Preface, Rev. 0
5