CY3660 Cypress Semiconductor Corp, CY3660 Datasheet - Page 7

• Manufacturer Part Number: CY3660
• Description: KIT DEV ENCORE V AND DVK
• Manufacturer: Cypress Semiconductor Corp
• Series: enCoRer
• Type: MCUr

Specifications of CY3660

• Contents: 4 Boards, Cable, CD, CY3210-MPAdapter, LCD Module, MiniProg Programmer, Power Supplies, Wire Kit
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Cypress PSOC MCU
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Not applicable / Not applicable

1.3
1.3.1
CY3660-enCoRe V and enCoRe V LV DVK Kit Guide, Doc. # 001-41500 Rev. **
Programming and Emulation Procedures
The following procedure provides a quick programming and emulation overview.
Note: Programming is done using either the PSoC MiniProg or the ICE-Cube. However, the ICE-
Cube is required for emulation. The ICE-Cube is available in the PSoC development kit and can be
ordered from Cypress's online store (PSoC Development Kit, CY3215-DK).
Programming Steps
1. If the LP Radio Module is connected to P2, remove it before the next step to avoid 5V being
2. Connect the USB cable to the PSoC MiniProg and to the PC. Connect the PSoC MiniProg to the
Figure 1-2. PSoC MiniProg
3. Launch PSoC Programmer version 3.00.0.92 or later. In PSoC Programmer, click Programming
4. Select the MiniProg port. If the Actions column in the PSoC Programmer status box indicates
5. For Programming Mode, select Power Cycle. Ensure the AC adapter is removed from P1, and
6. From the Device Family menu, select 64300.
7. From the Device menu, select CY7C64300-48LTXCT.
8. Click Program. PSoC Programmer goes through programming and verification modes.
9. Once programming is finished, remove the MiniProg from the CY3660 DVK board.
applied to the LP Radio Module. An alternative method is to use the CY3210-MPAdapt as a volt-
age translator. Please see the CY3210- MPAdapt Quick Start regarding how to use it.
5-pin ISSP header on the CY3660 DVK board.
→ File Load to load the desired binary (hex) file.
"Firmware update required at ...", the MiniProg's firmware is out of date. Before attempting to
program the target PSoC chip, go to Utilities → Upgrade Firmware to update the MiniProg's
firmware.
the USB cable is unplugged from P9.
Introduction
7
[+] Feedback