STEVAL-IDC001V1 STMicroelectronics, STEVAL-IDC001V1 Datasheet - Page 4

• Manufacturer Part Number: STEVAL-IDC001V1
• Description: BOARD DEVELOPMENT FOR ST72F561
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of STEVAL-IDC001V1

• Contents: Board
• For Use With/related Products: ST72F561
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8374; STEVAL-IDC001V1

Device specific information
1.3
Caution:
4/10
Implemented ICC features
Table 3
device. The data mentioned in this table is described in detail in the ICC protocol reference
manual.
Description of legends for
ICC monitor: Three different ICC monitors can be implemented: basic (for ST7 with
HDFlash and small XFlash), medium (for ST7 ROM) and advanced (for ST7 XFlash with
debug module). Refer to the ICC protocol reference manual for more details.
ICC mode entry: Different methods exists for entering ICC mode. Refer to the ICC protocol
reference manual for more details.
IAP:IAP is not available on 4K HDFlash versions.
ICD: ICD can be managed with or without a debug module, refer to the ICC protocol
reference manual for more details
DM: The Debug Module (DM) is an ST7 hardware peripheral able to manage instruction
stepping, complex breakpoints and abort for ICD development tools. The ST72F325,
ST7FSuperlite, ST7FLite2 and ST7FHUB Debug Modules do not feature the WP bit
capability and the register protection when MTR=0. Refer to the ICC protocol reference
manual for more details.
Ext clock: If this number of pulses is generated, the ST7 does not take into account the
option byte configuration stored in the Flash memory, and an external clock has to be
provided. In this case, the microcontroller configuration corresponds to the factory default
option byte values, see product datasheet for more details. Note that in this mode, reserved
Flash locations (which may contain internal oscillator calibration data for example) are not
write protected, and could be corrupted if you program the device using a wrong address.
To know on which pin the external clock must be provided please refer to the section related
to the ICC interface in the product datasheet.
Appli clock: If this number of pulses is generated, the ST7 takes into account the option
byte configuration (except the watchdog which is always software in this condition). In this
case, be sure that the selected clock source is available in the application (see product
datasheet for more details).
Note that in this mode, reserved Flash locations are write protected, so this mode is safer
than external clock mode.
defines the implemented ICC features and their main characteristics for each ST7
Table 3
ST7 Flash Programming