DEMO9S08JS16 Freescale Semiconductor, DEMO9S08JS16 Datasheet - Page 46

• Manufacturer Part Number: DEMO9S08JS16
• Description: BOARD DEMO FOR JS16 FAMILY
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S08JS16

• Contents: 2 Boards, Cable, Documentation, DVD
• Processor To Be Evaluated: MC9S08JS16
• Data Bus Width: 8 bit
• Interface Type: USB
• Operating Supply Voltage: 5 V
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: S08JS
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08JS16
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

11.2
42
CodeWarrior Installation Fails (WinDriver Error)
force windows to try to load the driver again, perform the following steps while
the DEMOJM interface is connected to the computer:
(B) Re-Install the USB driver
If the Multilink device does not show up in the device manager, use the driver
installation utility located in the DEMOJM Resources on the DVD-ROM. After
driver installation, unplug the DEMOJM from the PC and reboot the PC. When
the reboot has completed, connect the interface to the PC with the USB 2.0
cable. Run the software again to see if the interface is now detected.
If you have an error attempting to install the drivers, please view the
installation troubleshooting FAQ on P&E’s website at:
http://www.pemicro.com/faqs/faq_view.cfm?id=89.
(C) Test for installation of the USB driver files
To test the driver installation, use the driver test utility in the DEMOJM
Resources of the DVD-ROM to make sure all files were properly installed.
This may give some indication of what the problem is.
(D) Using a USB Hub
The DEMOJM is a high-power USB device. If a USB Hub is used, it must be a
self-powered hub (i.e., with its own power supply). If the Hub is not self-
powered the DEMOJM will not work. In general, USB ports located directly on
the PC are high-power (self-powered) ports.
Q: When I try to install the Codewarrior or P&E software, installation fails with
this message: “There are currently 2 open applications using WinDriver.
Please close all applications and press Retry. To reload WinDriver, press
1. Open the Control Panel (Start Button->Settings->Control Panel)
2. Double Click the "System" Icon
3. Select the "Hardware" tab
4. Click the "Device Manager" Button
5. The "P&E Multilink" device will be shown with an exclamation mark
6. Click the "Reinstall Driver…" button and follow the dialog instructions
next to it. Double-click this device.
to have Windows automatically install the driver.
DEMO9S08JS16 User Manual