DC-ME-9210-NET Digi International, DC-ME-9210-NET Datasheet - Page 27

• Manufacturer Part Number: DC-ME-9210-NET
• Description: KIT JUMP START ME 9210 NET+OS 7
• Manufacturer: Digi International
• Series: Digi Connect ME®r
• Type: MCU Moduler

Specifications of DC-ME-9210-NET

• Contents: Board, Cables, CD, Digi JTAG Link Hardware Debugger, Documentation, Module, Power Supply
• Data Rate: 10 Mbps to 100 Mbps
• Memory Type: SDRAM
• Interface Type: RS-232, Ethernet
• Operating Voltage: 12 V
• Operating Current: 346 mA
• Maximum Power Dissipation: 825 mW
• Operating Temperature Range: - 40 C to + 80 C
• Board Size: 36.7 mm x 19.05 mm
• Data Bus Width: 32 bit
• Modulation: CCK, DBPSK, DQPSK
• Product: Modules
• Security: 64/128 bit WEP, TKIP, WPA, WPA2
• Silicon Manufacturer: Digi Intl
• Kit Application Type: Communication & Networking
• Application Sub Type: Embedded
• Silicon Family Name: Digi Connect ME
• Rohs Compliant: Yes
• For Use With/related Products: Digi Connect ME 9210 Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1136

GPIO Switch Bank 1, SW3
User Push Button 1, SW1
User Push Button 2, SW2
27
      



See the figure titled "Board Layout and Connector Locations:" on page 17 for the location
of the switches. The following sections describe the switches.
GPIO Switch Bank 1, labeled SW3, is a set of five slide switches that allows the Digi
Connect ME embedded module to use either serial signals or GPIO signals to communicate
with a device. With the switch to the left position, the module’s signal is connected to the
Serial Port1 RS232 transceiver. In the right position, the module signal is connected to the
appropriate pin of the GPIO Port P7.
GPIO Switch Bank 1 Settings
When switch number 1 is set to GPIO-1, pushing User Push Button 1, SW1, will drive
GPIO-1 (module pin 13) low.
Pushing User Push Button 2, SW2, will drive module pin 18 low.
GPIO Switch Bank 1, SW3
Reset, SW4
Power On/Off SW5
Number
Switch
1
2
3
4
5
Left Position
DCD
DSR
DTR
CTS
RTS
Right Position
GPIO-1
GPIO-2
GPIO-3
GPIO-4
GPIO-5