STEVAL-IFS002V2 STMicroelectronics, STEVAL-IFS002V2 Datasheet - Page 14
![BOARD EVAL BASED ON LIS3LV02DL](/photos/9/19/91987/steval-ifs002v2_sml.jpg)
STEVAL-IFS002V2
Manufacturer Part Number
STEVAL-IFS002V2
Description
BOARD EVAL BASED ON LIS3LV02DL
Manufacturer
STMicroelectronics
Series
MEMSr
Specifications of STEVAL-IFS002V2
Sensor Type
Accelerometer, 3 Axis
Sensing Range
±2g, 8g
Interface
Analog and Digital
Embedded
No
Utilized Ic / Part
LIS302ALB, LIS302DL
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Voltage - Supply
-
Sensitivity
-
Other names
497-8261
Bill of materials and assembly instructions
6
6.1
6.2
14/20
Bill of materials and assembly instructions
Table 6
provide additional information on assembly.
Assembly information for analog MEMS
1.
2.
3.
Assembly information for digital MEMS
1.
2.
3.
use a voltage regulator. The maximum supply current is around 1.5 mA per device.
Operational amplifiers are optional.
a)
b)
c)
d)
Only ONE analog MEMS can be assembled. MEMS analog output pins are shared.
use a voltage regulator. Maximum supply current is around 1.5 mA per device.
Both I
a)
b)
c)
The board is designed to have one MEMS assembled on the board although I
SPI allows more devices to be used simultaneously. Care should be taken, however
with the RDY/INT pins, as they are shared.
When U10 LD2980CMxx is not assembled use R100 instead. For low voltage MEMS
When U11 LD2980CMxx is not assembled, use R110 instead. For low voltage MEMS
to
If they are not necessary, use resistors R80, R81, R82, R83 instead.
If they are required, use operational amplifiers with the following resistor
configuration.
R80, R81, R82, R83 - not assembled
R84, R86, R88, R90 - not assembled
R85, R87, R89, R91 - assembled with 0R.
To alter the gain of the operational amplifiers, use following resistor configuration.
R80, R81, R82, R83 - not assembled
The gain is determined by configuration of R84, R86, R88, R90 and R85, R87,
R89, R91.
In all cases it is recommended to have assembled filtering capacitors C84, C85,
C86, C87. Default is 10 nF, but this can be changed according to the required
filtering features.
The unused interface must be selected as floating input or third state.
When using I
which are 4.7 kΩ pull-ups.
When using SPI, each device has its own chip select.
Table 15
2
C and SPI are wired.
show the bill of materials, while sections
2
C, it is recommended to have assembled resistors R01 and R02
Section 6.1
to
Section 6.3
2
UM0542
C and