STEVAL-MKI092V1 STMicroelectronics, STEVAL-MKI092V1 Datasheet - Page 16

• Manufacturer Part Number: STEVAL-MKI092V1
• Description: BOARD DEMO FOR LIS331HH
• Manufacturer: STMicroelectronics
• Series: MEMS, nanor

Specifications of STEVAL-MKI092V1

• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±6g, 12g, 24g
• Interface: I²C, SPI
• Sensitivity: 12mg/digit, 6mg/digit, 3mg/digit
• Embedded: No
• Utilized Ic / Part: LIS331HH
• Acceleration: 6 g, 12 g, 24 g
• Sensing Axis: Triple Axis
• Interface Type: I2C, SPI
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: LIS331HH
• Other names: 497-10523

Application hints
4
4.1
16/37
Application hints
Figure 5.
The device core is supplied through Vdd line while the I/O pads are supplied through
Vdd_IO line. Power supply decoupling capacitors (100 nF ceramic, 10 µF Aluminum) should
be placed as near as possible to the pin 14 of the device (common design practice).
All the voltage and ground supplies must be present at the same time to have proper
behavior of the IC (refer to
without blocking the communication bus, in this condition the measurement chain is
powered off.
The functionality of the device and the measured acceleration data is selectable and
accessible through the I
The functions, the threshold and the timing of the two interrupt pins (INT 1 and INT 2) can be
completely programmed by the user through the I
Soldering information
The LGA package is compliant with the ECOPACK
It is qualified for soldering heat resistance according to JEDEC J-STD-020C.
Leave “Pin 1 Indicator” unconnected during soldering.
Land pattern and soldering recommendations are available at www.st.com.
LIS331HH electrical connection
Vdd
Digital signal from/to signal controller.Signal’s levels are defined by proper selection of Vdd_IO
100nF
GND
10µF
2
C or SPI interfaces.When using the I
Figure
Vdd_IO
Doc ID 16366 Rev 1
5). It is possible to remove Vdd maintaining Vdd_IO
1
5
5
16
6
TOP VIEW
2
C/SPI interface.
®
, RoHS and “Green” standard.
14
8
13
9
9
2
C, CS must be tied high.
INT 1
INT 2
LIS331HH