STEVAL-MKI077V1 STMicroelectronics, STEVAL-MKI077V1 Datasheet - Page 9
![BOARD DEMO LPR4150AL GYROSCOPE](/photos/28/40/284035/steval-mki077v1_sml.jpg)
STEVAL-MKI077V1
Manufacturer Part Number
STEVAL-MKI077V1
Description
BOARD DEMO LPR4150AL GYROSCOPE
Manufacturer
STMicroelectronics
Series
MEMSr
Specifications of STEVAL-MKI077V1
Design Resources
STEVAL-MKI077V1 Schematic
Sensor Type
Gyroscope, 2 Axis
Sensing Range
±1500°/sec
Interface
Analog and Digital
Sensitivity
0.67mV/°/s
Voltage - Supply
5V, USB
Embedded
Yes, MCU, 8-Bit
Utilized Ic / Part
LPR4150AL
Sensing Axis
Double Axis
Output Type
Analog, Digital
Interface Type
USB
Operating Voltage
5 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
LPR4150AL
Other names
497-10595
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
STEVAL-MKI077V1
Manufacturer:
STMicroelectronics
Quantity:
1
UM0701
5
5.1
5.1.1
Note:
System setup
The system consists of three boards: the STM32 demonstration board, the STM32-MEMS
demonstration board and the MEMS demonstration board. The set-up of the system can be
split into three main steps.
1.
2.
3.
4.
Steps 1 to 3 vary according to the type of STM32 demonstration board and MEMS
demonstration board used. They are described in the following chapters.
Regarding step 4: all MEMS demonstration boards compatible with the DIL24 socket can be
connected to the STM32-MEMS board. The correct orientation of the board is depicted in
Figure 4
Figure 4.
System setup with STM3210B-EVAL board
Connecting the STM32-MEMS board
Table 1.
The CN4 connector of the STM32-MEMS board is connected to the JP11 jumper of the
STM3210B-EVAL board in order to distribute V
JP16 jumper of the STM32-MEMS board takes over the V
JP11 jumper of the STM3210B-EVAL board.
Set-up of the STM32 demonstration board. In some cases, minor changes may have to
be made to the board.
Set-up of the jumpers on the STM32-MEMS board.
Connection of the STM32-MEMS board to the STM32 demonstration board.
Connection of the MEMS demonstration board to the STM32-MEMS board.
by the ST logo printed on the top side of the STM32-MEMS board.
Pin of STM32-MEMS board
Connecting MEMS demonstration board to STM32-MEMS board
Connecting the STM32-MEMS board to the STM3210B-EVAL board
CN1-1
CN2-1
CN4-1
Doc ID 15703 Rev 1
CC
to the MEMS sensor. In this setup, the
Connected to pin of STM3210B-EVAL
BAT
selection functionality of the
CN12-1
CN13-1
JP11-1
System setup
9/42