STEVAL-MKI013V1 STMicroelectronics, STEVAL-MKI013V1 Datasheet - Page 33
![BOARD EVALUATION FOR LIS302DL](/photos/9/18/91850/steval-mki013v1_sml.jpg)
STEVAL-MKI013V1
Manufacturer Part Number
STEVAL-MKI013V1
Description
BOARD EVALUATION FOR LIS302DL
Manufacturer
STMicroelectronics
Series
MEMSr
Specifications of STEVAL-MKI013V1
Design Resources
STEVAL-MKI013V1 Gerber Files LIS302DL Adapter to DIL24 Schematic LIS302DL Adapter to DIL24 Bill of Materials
Sensor Type
Accelerometer, 3 Axis
Sensing Range
±2.3g, 9.2g
Interface
I²C, SPI
Sensitivity
18 ~ 72 mg/Digit
Voltage - Supply
2.16 V ~ 3.6 V
Embedded
No
Utilized Ic / Part
LIS302DL
Sensing Axis
Triple Axis
Output Type
Digital
Tool / Board Applications
Sensing - Navigation, Accelerometer, Magnetic Field
Mcu Supported Families
LIS302DL
Supported Devices
LIS302DL
Rohs Compliant
Yes
Development Tool Type
Hardware - Daughter Card
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
497-6342
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
STEVAL-MKI013V1
Manufacturer:
STMicroelectronics
Quantity:
135
Company:
Part Number:
STEVAL-MKI013V1
Manufacturer:
STMicroelectronics
Quantity:
1
UM0701
7.5.1
Note:
STM32-MEMS USB demonstration application
The STM32-MEMS USB demonstration application reads data from the MEMS sensor and
sends it over USB to a PC. On the PC side runs the MEMS USB Reader (Windows GUI
application), which use an HID class of USB interface to receive data sent by the
demonstration application.
It is possible to use any of the compatible MEMS demonstration boards (see list in previous
section) without changing the firmware. However, do not forget to change the jumper
settings on the STM32-MEMS demonstration board if needed (for example, when changing
from an analog MEMS to a digital one).
Follow these steps to run the demonstration application.
1.
2.
3.
4.
5.
6.
In most cases it is necessary to power-down and power-up the system after flashing the
STM32 MCU before plugging it to a PC.
Figure 19
Mount the STM32-MEMS demonstration board onto the STM32 demonstration board
and mount the MEMS demonstration board onto the STM32-MEMS demonstration
board.
Correctly set-up the jumpers on the STM32-MEMS demonstration board.
Go to the IAR EWARM IDE in Project/Options/General Options and select the device
corresponding to the one used on your STM32 demonstration board (either ST
STM32F10xxB or ST STM32F10xxE).
In the stm32_mems_adapter.h file uncomment one line corresponding to the STM32
demonstration board used.
Compile, flash and run the project.
Run the MEMS USB Reader on the PC.
shows the MEMS USB Reader Windows GUI application.
Doc ID 15703 Rev 1
STM32-MEMS development kit
33/42