STEVAL-MKI030V1 STMicroelectronics, STEVAL-MKI030V1 Datasheet - Page 18

• Manufacturer Part Number: STEVAL-MKI030V1
• Description: BOARD DEMO STM8S207R6/LIS331DLH
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI030V1

• Design Resources: STEVAL-MKI030V1 Schematic
• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±2g, 4g, 8g
• Interface: I²C, SCI
• Sensitivity: 3.9mg/digit, 2mg/digit, 1mg/digit
• Voltage - Supply: 4.5V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LIS331DLH, STM8S207R6T6
• Sensing Axis: Triple Axis
• Operating Voltage: 5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8852

Product overview
4.8
4.9
4.10
4.11
18/105
Independent watchdog timer
The independent watchdog peripheral can be used to resolve processor malfunctions due to
hardware or software failures.
It is clocked by the 128 kHZ LSI internal RC clock source, and thus stays active even in case
of a CPU clock failure
The IWDG time base spans from 60 µs to 1 s.
Auto wakeup counter
●
●
●
Beeper
The beeper function outputs a signal on the BEEP pin for sound generation. The signal is in
the range of 1, 2 or 4 kHz.
TIM1 - 16-bit advanced control timer
This is a high-end timer designed for a wide range of control applications. With its
complementary outputs, dead-time control and center-aligned PWM capability, the field of
applications is extended to motor control, lighting and half-bridge driver
●
●
●
●
●
●
●
TIM2, TIM3 - 16-bit general purpose timers
●
●
●
●
●
Used for auto wakeup from active halt mode
Clock source: Internal 128 kHz internal low frequency RC oscillator or external clock
LSI clock can be internally connected to TIM3 input capture channel 1 for calibration
16-bit up, down and up/down autoreload counter with 16-bit prescaler
Four independent capture/compare channels (CAPCOM) configurable as input
capture, output compare, PWM generation (edge and center aligned mode) and single
pulse mode output
Synchronization module to control the timer with external signals
Break input to force the timer outputs into a defined state
Three complementary outputs with adjustable dead time
Encoder mode
Interrupt sources: 3 x input capture/output compare, 1 x overflow/update, 1 x break
16-bit autoreload (AR) up-counter
15-bit prescaler adjustable to fixed power of 2 ratios 1…32768
Timers with 3 or 2 individually configurable capture/compare channels
PWM mode
Interrupt sources: 2 or 3 x input capture/output compare, 1 x overflow/update
Doc ID 14733 Rev 11
STM8S207xx, STM8S208xx