400293 Bergquist, 400293 Datasheet - Page 3
![KIT STARTER FOR TOUCH SCREEN MOD](/photos/9/17/91781/400293_sml.jpg)
400293
Manufacturer Part Number
400293
Description
KIT STARTER FOR TOUCH SCREEN MOD
Manufacturer
Bergquist
Specifications of 400293
Sensor Type
Touch Screen
Interface
USB, PS/2, or Serial (RS-232)
Voltage - Supply
5 V ~ 24 V
Embedded
No
Utilized Ic / Part
500499
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Sensitivity
-
Sensing Range
-
Other names
BER245
COMPLETE THE INSTALLATION PROCESS:
12. Click “Finish” (see Figure 6).
13. Reboot your computer when prompted to do so.
NOTE: When the computer reboots, the touch screen will be functional, but it will
not be calibrated.You must calibrate the touch screen using the following configuration
procedure before the touch screen will work properly.
STARTING THE 5-WIRE DRIVER CONTROL
PANEL:
Refer to Figure 7.
14. Run the Bergquist 5-Wire Control Panel as follows:
CONFIGURING YOUR 5-WIRE CONTROLLER(S)
FOR MULTI-MONITOR USE:
Refer to Figure 8. A graphic representation of the monitor(s) installed on your
system will be displayed. If you are using a single monitor, skip to Configure
Calibration Options on the next page. Note: Microsoft does NOT support multi-
monitor function for Win98.
15. Select the image of the display whose properties you would like to adjust.
Start Menu > Programs > Bergquist Touch Screen Control Panel
If you do not interact with the Control Panel within 10 seconds, the Bergquist
calibration program will be launched (see “Configure Calibration Options”).
Once a monitor image is selected, all subsequent configuration settings will be
associated with that monitor.
Once you have configured one of the monitors, select the other display images to
adjust its associated properties.
Figure 8
Touch Screen Controller User's Guide - 3
Figure 6
Figure 7