400293 Bergquist, 400293 Datasheet - Page 2
![KIT STARTER FOR TOUCH SCREEN MOD](/photos/9/17/91781/400293_sml.jpg)
400293
Manufacturer Part Number
400293
Description
KIT STARTER FOR TOUCH SCREEN MOD
Manufacturer
Bergquist
Specifications of 400293
Sensor Type
Touch Screen
Interface
USB, PS/2, or Serial (RS-232)
Voltage - Supply
5 V ~ 24 V
Embedded
No
Utilized Ic / Part
500499
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Sensitivity
-
Sensing Range
-
Other names
BER245
SELECT 5-WIRE CONTROLLER TYPE:
Refer to Figure 3.The “12 or 10 Bit Controller” is automatically selected for you.
7. In the “Controller Interface” field, select “Serial (RS-232), ” “USB” or “PS/2, ”
8. Click “Next. ”
AUTOMATICALLY DETECT A
SERIAL 5-WIRE CONTROLLER:
Refer to Figure 4.
9. Select the “Autodetect” option to automatically detect any of the 5-Wire RS-232
MANUAL SERIAL CONTROLLER SETUP:
Refer to Figure 5. If your computer did not detect your 5-Wire controller, or if you
have configured your controller integration in a non-typical configuration, you may
manually setup the 5-Wire controller board for RS-232.
10. Select the communications port, the IRQ settings, the base address and the baud
11. Click “Next. ”
2 - Touch Screen Controller User's Guide
IMPORTANT: Use “Autodetect” for serial communications only.
depending on your application.
touch screen controller products.
If you select the “Serial (RS-232)” interface, you may click the “Autodetect” button
to find your controller and set the appropriate settings (see “Automatically Detect
A Serial 5-Wire Controller, ” below for selecting the communication interface.)
If you are using a USB controller, the controller will automatically be detected by
your system at startup.
If you are using a PS/2 controller, select the “PS/2” controller interface option to
load the appropriate device driver.
If you have a custom controller that is set to some other baud rate, select the
appropriate baud rate.
rate. Note: All 5-Wire controller boards default to 9600 baud.
Figure 3
Figure 4
Figure 5