ZEPIR000101ZCOG Zilog, ZEPIR000101ZCOG Datasheet - Page 5

• Manufacturer Part Number: ZEPIR000101ZCOG
• Description: BOARD COMPUTER SGL EPIR ZDOT
• Manufacturer: Zilog
• Series: Zdots® SBCr

Specifications of ZEPIR000101ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: 5m x 5m, 60 Degree Detection Pattern
• Interface: UART or Hardware
• Sensitivity: Adjustable
• Voltage - Supply: 2.7 V ~ 3.6 V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ZEPIR0AAS01SBCG
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 269-4711

Introduction
ZMOTION
UM022305-1110
Zilog’s ZMOTION
needed to evaluate and begin development with the ZMOTION
The kit includes an Evaluation Board into which the ZMOTION
and a prototyping area to add your own custom application hardware.
The ZMOTION
1. Evaluate the ZMOTION
2. Evaluate the ZMOTION
3. Experiment with your own hardware using the prototype area on the Evaluation Board.
4. Using a separately purchased USB Smart cable (debugger) and ZDS-II - Zilog’s Integrated
Zilog’s ZMOTIONTM Detection Module is a complete and fully functional motion detection
solution ideal for lighting control and other occupancy and proximity detection applications. It is
a board level module that combines the unique features of Zilog’s Z8FS040 ZMOTION™
Detection Microcontroller with a Pyroelectric Sensor and a low profile Fresnel lens.
The ZMOTION™ Detection Module can operate in a simple to use Hardware mode which
provides an output signal when motion is detected; or in an advanced asynchronous serial
mode when greater control over the motion detection performance is needed. In both modes
sensitivity and delay time can be controlled to match the application requirements.
The features of ZMOTION
pots located on the base board to control sensitivity, range and output timing.
advanced control over its settings and performance. Use the kit to tailor the settings
needed for your own custom application.
Development Environment, develop your own custom S/W applications on the
ZMOTION












TM
Complete, fully functional motion detector including lens
Small form factor: 25.5 mm x 16.7 mm
Wide 5 m x 5 m, 60 degree detection pattern
Sensitivity control via simple hardware configuration
Advanced commands and control via serial (asynchronous) interface
Sleep mode for low power applications
No temperature compensation required
Input to support CDS photocell input for ambient light detection
Minimal components ensure highest possible Mean Time Between Failures (MTBF)
Operates from 2.7 V to 3.6 V power supply
Simple 8-pin interface
Standard operating temperature 0 ºC to 70 ºC
TM
Detection Module
TM
Detection Module.
TM
Detection Module Evaluation Kit is intended for the following purposes:
Detection Module Evaluation Kit includes all the necessary components
TM
TM
TM
Detection Module include:
Detection Module in hardware mode using jumpers and trim
Detection Module using the built-in serial interface to gain
ZMOTION
TM
TM
TM
Detection Module Evaluation Kit
Detection Module is plugged
Detection Module.
User Manual
5