NCP102MBGEVB ON Semiconductor, NCP102MBGEVB Datasheet - Page 2

• Manufacturer Part Number: NCP102MBGEVB
• Description: EVAL BOARD FOR NCP102MBG
• Manufacturer: ON Semiconductor

Specifications of NCP102MBGEVB

• Design Resources: NCP102 Demo Brd BOM NCP102MBGEVB Gerber Files NCP102 EVB Schematic
• Channels Per Ic: 1 - Single
• Voltage - Output: 1.2V
• Current - Output: 3A
• Voltage - Input: 1.8V
• Regulator Type: Positive Fixed
• Board Type: Fully Populated
• Utilized Ic / Part: NCP102
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Operating Temperature: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: NCP102MBG
• Other names: NCP102MBGEVBOS

Test Procedure:
Establish Setup
1/22/08
Required Equipment:
1.
a.
b.
c.
2.
3.
1.
2.
Note: for measurement accuracy, the DMMs must be connected
to the Demonstration Board terminals and not the DC supply or
load terminals. This is particularly true for DMM 2 and DMM 3.
3.
4.
5.
3 DC Power Supplies:
“Vin supply” possessing a minimum voltage rating of 5 VDC
and minimum current rating of 4 ADC; for example, HP
6282A.
“Vcc supply” possessing a minimum voltage rating of 15
VDC and minimum current rating of 1 ADC; for example, ½
Agilent e3649A dual supply.
“N_Enable supply” possessing a minimum voltage rating of
5.5 VDC and minimum current rating of 0.1 ADC; for
example, ½ Agilent e3649A dual supply.
3 Auto-ranging Digital Multimeters (DMMs): each
possessing a minimum voltage rating of 20 VDC and
minimum current rating of 2ADC; for example, Keithley 175.
1 Electronic Load: possessing a current display and
minimum current capability of 4 ADC; for example, Kikusui
PLZ303W.
Connect the NCP102 Demonstration Board as shown in
Figure 1.
Adjust the N_Enable supply to 4.5VDC while observing the
indicator on the supply.
Connect DMM 1 to Vcc and configure as a voltmeter. Set
DMM 1for auto-range.
Connect DMM 2 to Vin and configure as a voltmeter. Set
DMM 2 for auto-range.
Connect DMM 3 to Vout and configure as a voltmeter. Set
DMM 3 for auto-range.
NCP102 Demonstration Board Test Procedure
2 of 4
REV 1