STEVAL-ISA036V1 STMicroelectronics, STEVAL-ISA036V1 Datasheet - Page 7

• Manufacturer Part Number: STEVAL-ISA036V1
• Description: BOARD EVAL BASED ON STC04IE170
• Manufacturer: STMicroelectronics
• Type: Motor / Motion Controllers & Driversr

Specifications of STEVAL-ISA036V1

• Main Purpose: AC/DC, Primary Side
• Outputs And Type: 1, Isolated; 2, Non-Isolated
• Power - Output: 5W
• Voltage - Output: 5V, 15V, 15V
• Current - Output: 600mA, 66mA, 66mA
• Voltage - Input: 200 ~ 1200V
• Regulator Topology: Flyback
• Board Type: Fully Populated
• Utilized Ic / Part: L6565, STC04IE170HP
• Input Voltage: 200 V to 1200 V
• Output Voltage: 15 V
• Product: Power Management Modules
• Silicon Manufacturer: ST Micro
• Silicon Core Number: STC04IE170HP
• Kit Application Type: Power Management
• Application Sub Type: SMPS
• Kit Contents: Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Frequency - Switching: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: STC04IE170HP
• Other names: 497-6417; STEVAL-ISA036V1

L6565
APPLICATION INFORMATION
Quasi-resonant operation in offline flyback converters lies in synchronizing MOSFET's turn-on to the transform-
er's demagnetization. Detecting the resulting negative-going edge of the voltage across any winding of the
transformer can do this. The L6565 is provided with a dedicated pin that allows doing the job with a very simple
interface, just one resistor.
Variable frequency operation - as a result of different operating conditions in terms of input voltage and output
current - is inherent in such functionality. The system always works close to the boundary between DCM (Dis-
continuous Conduction Mode) and CCM (Continuous Conduction Mode) operation of the transformer. The op-
eration is then identical to that of the so-called self-oscillating or Ringing Choke Converter (RCC).
Detailed Device Description
Internal Supply Block (see fig. 12)
A linear voltage regulator supplied by V
(pin 8) generates an internal 7V rail used for supplying the entire IC,
cc
except for the gate driver that is supplied directly from Vcc. In addition, a bandgap circuit generates a precise
internal reference (2.5V±1% @ 25°C) used by the control loop to ensure a good regulation with primary feed-
back technique.
In figure 12 it is also shown the undervoltage lockout (UVLO) comparator with hysteresis used to enable the
chip as long as the Vcc voltage is high enough to ensure a reliable operation.
Figure 12. L6565 internal supply block
+V
in
Vcc
8
-
+
UVLO
LIN.
REF.
REG.
2.5V
7V bus
7/17