IRMD2214SS International Rectifier, IRMD2214SS Datasheet - Page 6

• Manufacturer Part Number: IRMD2214SS
• Description: KIT DESIGN EVAL BOARD IR2214SS
• Manufacturer: International Rectifier
• Series: HVICr

Specifications of IRMD2214SS

• Main Purpose: Power Management, Half H-Bridge Driver (External FET)
• Utilized Ic / Part: IR2214SS
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Other names: *IRMD2214SS

The SHU, SHV and SHW are sense pins connected as close as possible to the shunt resistors terminals
to reduce the parasitic effects of the traces.
High power signal connector
There are two connectors dedicated to each power signal (DC+, U, V, W and DC-). Each single
connector has 30 Ampere of maximal nominal dc current. DCbus traces are both on top and on one of
the internal layers of the PC board in order to reduce power dissipation. Connectors, DC-bus, phase and
ground wires can be soldered directly on board using the corresponding pads located under the power
connectors (to be removed).
Connecting the power module
The board is fully compatible with the ECONO2-6PACK power module. The following table shows the
module pin-out.
www.irf.com
CONNECTION POINTS BETWEEN BOARD AND MODULE
10
11
12
13
14
15
16
17
1
2
3
4
5
6
7
8
9
Table 3: High power module connection
VGHU - phase U - high side IGBT gate
VEHU - phase U - high side IGBT emitter
VGLU - phase U - low side IGBT gate
VELU - phase U - low side IGBT emitter
VGHV - phase V - high side IGBT gate
VEHV - phase V - high side IGBT emitter
VGLV - phase V - low side IGBT gate
VELV - phase V - low side IGBT emitter
VGHW - phase W - high side IGBT gate
VEHW - phase W - high side IGBT emitter
VGLW - phase W - low side IGBT gate
VELW - phase W - low side IGBT emitter
DC+
Phase W
Phase V
Phase U
DC- (GND)
page
6/22
Datasheet rev 2.1
IRMD22141SS
Sep 9
th
, 2004