STEVAL-SPMD250V2 STMicroelectronics, STEVAL-SPMD250V2 Datasheet - Page 12

• Manufacturer Part Number: STEVAL-SPMD250V2
• Description: BOARD EVAL SPMD250
• Manufacturer: STMicroelectronics
• Series: EASY POWER™r
• Type: Motor / Motion Controllers & Driversr

Specifications of STEVAL-SPMD250V2

• Main Purpose: Power Management, Motor Control
• Embedded: No
• Utilized Ic / Part: SPMD250
• Primary Attributes: 2-Ph Bipolar Stepper Motors
• Secondary Attributes: Remote Shutdown
• Input Voltage: 12 V to 40 V
• Board Size: 140 mm x 90 mm
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 24 V
• Product: Power Management Modules
• Supply Current: 2 A
• Dimensions: 140 mm x 90 mm
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• For Use With/related Products: SPMD250STP
• Other names: 497-10050

5
Note:
12/15
STEVAL-SPMD150V1, STEVAL-SPMD150V2
STEVAL-SPMD150V1, STEVAL-SPMD150V2
To make the boards operative, perform the following simple steps:
●
●
●
●
●
●
●
●
If the internal reference of SPMD150STP is used, connect jumpers JR1, JR2, JR5, JR6; in
this way the motor current is fixed and no more controlled by PractiSPIN™.spmd SW.
Figure 8.
Connect them to the control board by means the 34-wire flat cable and the control
board to the host PC
Connect the stepper motor to P3 and P4 connector
Put jumpers on JR1, JR2, JR3A, JR3B
Apply 5 V to P1 connector
Apply motor voltage VS to P2 connector
Launch the PractiSPIN™.spmd program on the host PC
Click on "connect to ST7 hardware" and perform calibration
–
–
Click done and enter in "speed control mode" or "indexing mode"
Click on calibrate zero and trim R18 on control board until voltage on VREFA and
VREFB is zero.
Click on calibrate max and set the maximum current, corresponding to 100%
current setting in the PractiSPIN™.spmd software, adjusting RV1 (VREFA) and
RV2 (VREFB) trimmers on the target board. The relationship voltage/current is
V = 0.165 I
STEVAL-SPMD150V1 / STEVAL-SPMD150V2 demonstration system
motor
.
Doc ID 15599 Rev 2
AM04226v1
UM0696