IS-DEV KIT-5 NKK Switches, IS-DEV KIT-5 Datasheet - Page 14
![SMARTSWITCH DEVELOPMENT KIT 5](/photos/9/5/90525/mfg_is-dev_kit-5_sml.jpg)
IS-DEV KIT-5
Manufacturer Part Number
IS-DEV KIT-5
Description
SMARTSWITCH DEVELOPMENT KIT 5
Manufacturer
NKK Switches
Series
SmartSwitch™r
Datasheet
1.IS-L0251-C.pdf
(24 pages)
Specifications of IS-DEV KIT-5
Main Purpose
Switches with Programmable Display
Utilized Ic / Part
IS15ABFP4RGB
Primary Attributes
2 LCD Switches, PC Board with Flash Memory
Secondary Attributes
Power and Programming Connections
Description/function
SMARTSWITCH Development Kit
For Use With
360-2431 - SERIAL CBL RJ11-DB9 FOR DEV KIT360-2430 - POWER SUPPLY 240VAC FOR DEV KIT360-2429 - POWER SUPPLY 120VAC FOR DEV KIT
Lead Free Status / RoHS Status
Not applicable / Not applicable
Embedded
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
For Use With/related Products
Smart Switch - RGB
Other names
360-2328
7850 East Gelding Drive • Scottsdale, AZ 85260-3420
Command to set LED on cycle duration
[LED ON/OFF cycle] is one byte.
Duration of ON cycle = ([LED ON/OFF]-1) *(duration of OFF cycle)
This command is for duration of the session. It can become permanent by “Command to write the setup
values to the EPROM”.
Command to set FLAG A
[FLAG A] is one byte. See table below.
This command is for duration of the session. It can become permanent by “Command to write the setup
values to the EPROM”.
IS-Dev Kit-5 and IS-Dev Kit-6 Users Manual A.doc
This command sets the duration of the on cycle.
This command sets Flag A.
B0
B1
B2
B3
B4
B5
B6
B7
Bit
command format:
transmit format:
command format:
transmit format:
Flag Byte A Default Value=7EH
Enable
Value
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone 480.991.0942 • Fax 480.998.1435
1
1
1
1
1
1
1
1
LED press flag
61H flag
79H flag
Switch release report flag
6EH flag
Switch press report flag
Timer 1 and 2 expire report flag
Address change report flag
(xxH) (xxH) (xxH)
(xxH) (xxH) (xxH)
26H
26H
IS-Dev Kit-5 and IS-Dev Kit-6 Users
www.nkkswitches.com • Email engineering@nkkswitches.com
51H
51H
Flag
5BH [FLAG A]
59H
[LED ON/OFF cycle]
Manual
(xxAH)
(xxAH)
Switch backlight change according to LED
press value while the switch is pressed.
For LCD 36x24 only.
61H is transmitted in response to
command.
79H is transmitted upon completion of
command.
Switch releases are reported
6EH is transmitted if there is any error
during communication to host.
Switch presses are reported
Timer 1 and 2 expiration is reported
Newest address is reported for each switch
Controller action when flag is set
Page 14 of 24
1209