DM330021 Microchip Technology, DM330021 Datasheet - Page 27
![KIT DEMO DSPIC33 MCLV](/photos/9/4/90441/dm330021_sml.jpg)
DM330021
Manufacturer Part Number
DM330021
Description
KIT DEMO DSPIC33 MCLV
Manufacturer
Microchip Technology
Series
dsPIC™r
Datasheet
1.DM330021.pdf
(40 pages)
Specifications of DM330021
Main Purpose
Power Management, Motor Control
Embedded
Yes, MCU, 16-Bit
Utilized Ic / Part
dsPIC33F
Primary Attributes
3-Ph BLDC or PMSM, 48V, 15A
Secondary Attributes
CAN, LIN, USB, RS-232 Interfaces
Processor To Be Evaluated
dsPIC33F
Interface Type
RS-232, USB
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
DM330021
Manufacturer:
Microchip Technology
Quantity:
135
Company:
Part Number:
DM330021-2
Manufacturer:
MICROCHIP
Quantity:
12 000
3.1
3.2
© 2008 Microchip Technology Inc.
Chapter 3. Running a BLDC Motor Using Hall Sensors
HARDWARE REQUIREMENTS
dsPICDEM MCLV DEVELOPMENT BOARD SETUP
This chapter describes how to set up the dsPICDEM MCLV Development Board to run
a BLDC motor using Hall sensors.
Refer to the application note, AN957
dsPIC30F2010” (DS00957), for more information about running the BLDC motor control
using Hall sensors. Topics covered include:
• Hardware Requirements
• dsPICDEM MCLV Development Board Setup
To set up and run the board, the following items are recommended:
• dsPICDEM MCLV Development Board (DM330021)
• 24V power supply (AC002013) or equivalent
• 10 pole Hurst motor (AC300020)
• dsPIC33FJ32MC204 PIM (MA330017)
The following procedure describes how to set up the dsPICDEM MCLV Development
Board:
1. Place the dsPICDEM MCLV Development Board on a sturdy insulated platform.
2. Make sure that the dsPIC33FJ32MC204 device or an appropriate PIM is
Note 1:
mounted in the respective socket.
2:
The dsPICDEM MCLV Development Board is intended to drive the
three-phase BLDC or PMSM motor. Before connecting the motor, make
sure that the power rating of the motor is equal to or less than the power
rating of the board, as shown in Appendix B. “Electrical
Specifications”. Also, make sure the jumper settings are correct for the
firmware programmed into the target dsPIC DSC device mounted on the
socket. Failure to comply with this warning could lead to malfunction of
the board and the motor, and could result in physical harm.
Before beginning the start-up procedure, complete a visual check of the
board and the motor for connectivity and mechanical damage. If damage
is found, DO NOT power-up the board. Otherwise, you may further
damage the equipment. Contact Microchip’s local office or distributor
immediately.
“
WARNING
Sensored BLDC Motor Control Using
DEVELOPMENT BOARD
dsPICDEM
USER’S GUIDE
TM
DS70331A-page 23
MCLV