AC164120 Microchip Technology, AC164120 Datasheet - Page 13

• Manufacturer Part Number: AC164120
• Description: BOARD SIGNAL ANALYSIS PICKIT
• Manufacturer: Microchip Technology
• Series: PICtail™r

Specifications of AC164120

• Main Purpose: Interface, Signal Analysis
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: PICkit™ PICtail™1
• Primary Attributes: Real-time Strip Chart, Oscilloscope, Fast Fourier Transformation (FFT)
• Secondary Attributes: Histogram
• Silicon Manufacturer: Microchip
• Core Architecture: PIC
• Core Sub-architecture: PIC16
• Features: Real-Time Strip Chart, Fast Fourier Transformation
• Silicon Core Number: PIC16F
• Silicon Family Name: PIC16F6xxx
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: PICkit Flash Starter Kit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

 2004 Microchip Technology Inc.
1.4.2
Figure 1-2 shows how the Signal Analysis PICtail Daughter Board plugs into the
PICkit 1 Flash Starter Kit expansion header J3. The Signal Analysis Board electrically
detaches the PICkit 1 onboard LED array. The target PICmicro device is plugged into
the Signal Analysis Board DIP socket U1. Remove any PICmicro devices from the
Evaluation Socket on the PICkit 1 Flash Starter Kit.
FIGURE 1-2:
Figure 1-3 shows the electrical connections of the Signal Analysis PICtail Daughter
Board with the PICkit 1 Flash Starter Kit. There are five connections: +5V, Ground,
ICSPCLK, ICSPDAT and V
Schematics”). These signals allow the target PICmicro device, plugged into U1 DIP
socket on the Signal Analysis PICtail Daughter Board, to be programmed and provide
bidirectional synchronous serial communications with the PICkit 1 PIC16C745 micro-
controller with USB device. With PICkit 1 V2.0.0 (or later) firmware, the user can
communicate to and from the target PICmicro device via USB serial communications.
This facilitates PC host programs to command, control and communicate with the
target PICmicro device that is being evaluated or for program development.
Note: When the Signal Analysis PICtail Daughter Board is plugged into the
USB Cable
PIC16C745 Firmware
Version 2.0.0 or later
Electrical Connections
PICkit 1 Flash Starter Kit, remove any PICmicro devices from the Evalua-
tion Socket on the PICkit 1. The target PICmicro device used for evaluation
and development is plugged into the DIP socket U1 on the Signal Analysis
Daughter Board.
Signal Analysis PICtail™ Daughter Board
Expansion
Header (J3)
ORIENTATION
SIGNAL ANALYSIS PICtail™ DAUGHTER BOARD
PP
(see Figure A-1 in Appendix A. “Hardware
PICkit 1™ Flash Starter Kit
Signal Analysis
PICtail™ Daughter Board
Remove PICmicro
from Evaluation Socket
DS51476A-page 9
®
Device