PCA4988 Renesas Electronics America, PCA4988 Datasheet - Page 133

• Manufacturer Part Number: PCA4988
• Description: DEV 80D0 TO 40-PIN DIL STD PITCH
• Manufacturer: Renesas Electronics America

Specifications of PCA4988

• Module/board Type: Converter Board
• For Use With/related Products: PC4701
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Appendix I
SSOP
Shrink Small Outline Package
Stacked CSP
Stacked Chip Size/Scale Package
TQFP
Thin Quad Flat Package
TQPACK (made by Tokyo Eletech Co., Ltd.)
Board that is mounted on the target system's foot pattern and used
to connect to the emulator via the TQSOCKET (male side)
TQSOCKET (made by Tokyo Eletech Co., Ltd.)
Socket used to connect TQPACK and board (female side).
TSOP
Thin Small Outline Package
ZIP
Zigzag In-line Package
Accessory Tool
This is a generic name used for pitch converters, dummy IC,
temporary target boards, and oscillator boards.
Emulator Probe
Emulator's tip part.
*All brand names and product names are trademarks or registered trademarks of their respective companies.
Dummy IC
The dummy IC means a temporary MCU that has the same
dimensions as those of the MCU package and is used to connect
the emulator probe and target system together. At the top it has a
connector to connect to the emulator probe. Then, after being
assembled with a socket frame and socket (included with the
package), it is attached to the foot pattern on the target system.
Also, during board-mounted evaluation, you can use this same
socket to mount an MCU of the same type as the dummy IC. Use
of the dummy IC allows the IC sockets conventionally used on
the target system during debugging or board-mounted evaluation
to be shared among various types of MCUs.
Temporary Target Board (for 8-bit MCU)
This board allows developers to evaluate the emulator MCU
independently as a single unit by applying the minimum signals
required to operate the emulator MCU (e.g., VCC, GND,
CNVSS, clock and RESET). Developers can use this board when
wanting to proceed with software development or verify the
operation of the PC4701/PC4600 system in cases where the target
system is not available. Some signals such as VCC, GND and
CNVSS must be externally supplied. The RESET signal can be
supplied by the emulation pod that is designed for use with the
PC4701/PC4600. The clock signal can be taken from the
on-board oscillator circuit.
Burn-in IC Socket
IC socket used for evaluation purpose.
Package Converter
Use this converter to convert the pitch of your MCU or emulator
probe to the same pitch as the MCU foot pattern on the target.
Standard Pitch (2.54mm) Converter
When the user system is built on a universal board, use this
converter to convert the pitch of your MCU or emulator probe to
the standard pitch.
Bare
Board without any parts mounted.
Converter (Pitch Converter)
This means a board that is used to convert an IC package's pin
pitch and signal arrangement. When broadly classified, main
products are either a package converter and a standard pitch
converter.
Rev.1.00 2004.06 Page 133 of 135